Won't start how ? When you turn the key to the start position does the starter spin the engine ? Or not ? This would be a no crank - no start condition ! Or when you turn the key to start the starter spins over the engine but it doesn't start an run ? This is a crank - no start condition . Both have very different diagnostic testing procedures ! An what won't say anything ? Is there a car an padlock symbol lit on the instrument cluster ?
SOURCE: Burning rubber smell inside car-2003 CTS Cadillac
Diagnosing this will be subject to a process of elimination. It could be the radio, blower motor or any other accessory particularly ones with moving parts; Try switching those off and try to note when this problem occurs and what is on/whatyou are doing. Something is getting hot causing the smell so it will be a situation where the accessory will have to run a while before doing it. It is a possibility that there is an electical curcuit overheating, but less likely. Lets rule out accessories first and give us an update. GL
SOURCE: how do I replace the tail light bulb on my
ok cadillac for some reason has to be difficult about these things you actually have to take the whole tail light assembly out. . .here is what youre going to need:
1. socket wrench
2. number 10 socket (gm's nut of choice)
3. patience because it is easy to drop the nut be careful
ok so you have to open the trunk then take the plastic that holds the carpet down off. you do this by unscrewing the black screw on pegs (not sure what to call these things). after you do this pull the plastic thing hard because it is being held in place by some pegs other than the ones you have already removed. then remove all the side carpeting depending on which side youre changing. ok after this look directly behind the tail light assembly for 2-3 (i forget how many) bolt like pegs (my new favorite word) these are attached to the plastic tail light assembly. then take the nuts off of these pegs and then you should be able to tug the assembly off. then you do what the others say take out the socket and replace the bulb.
like i said cadillac makes **** hard to do. if you hate this wait til you have to take the whole bumper off to replace the headlight bulbs (might want to invest in some hid lights so you wont ever have to replace them)
good luck
SOURCE: Replace 2005 Cadillac CTS water pump
drain the coolant.remove belt by rotating belt tensioner cllockwise. water pump pulley will require a holding tool to keep it from turning while removing bolts. access to air ratchet can sometimes eliminate the need to hold but be careful cause thats a good way to skin some knuckles. also make installation more difficult to obtain proper torque. after pulley is off just a few water pupm mounting bolts remain. clean and dry gasket surface very well before reinstalling.
Testimonial: "Very quick with a response, and good info!"
SOURCE: HOW TO REPLACE A BREAK LIGHT SWITCH
The brake light switch itself is located on the brake pedal follow it down until you see where it connects and unplug the connection ...after installation make sure the brake light switch is correctly adjusted by having a 2nd person stand behind the vehicle as you press the pedal the light should come on if not adjust the switch higher up by turning the switch inward ..or upwards by screwing it in if it constantly on unscrew it until lights go out and its fairly easy once you actually look at the part and the pedal ...i hope that helps you
SOURCE: cadillac cts cranks but won't start
My 2003 CTS would not start on the first, second or third try after filling the gas tank. Finally after several months of this occuring every two weeks a check engine light came on. It was the evac purge valve. Tom
382 views
Usually answered in minutes!
×