2000 pontiac montana - brake lights stay on - all wires disconnected from switches at pedal

Are you referring to the brake lights.If so the brake light switch on top of the brake pedal is stuck.Try freeing it with some contact leaner or replace it

be sure that brake pedal is all the way up even if you have to pull it up or thers a wire shorted

Have you unplugged the brake switch to see if the problem stops ?

On the brake pedal is a brake light switch. This switch is frozen in the on position. You will need to have this removed and replaced. This should fix your problem.

Check the adjustment on the brake light switch directly above the brake pedal

change your brake light switch located on your brake pedal.

Sounds like your hazard switch is going bad. There were a few years where the switches for the hazard lights would go bad, and since they overlap two systems; the brake lights, and the turn signals/flashers, it would cause all sorts of crazy things to happen. Because of the circuit overlap, normally if you step on the brakes while the warning flashers are on, the flashers stop working. You'll have to replace the switch for the 4-way flashers, and it should fix you right up. Don't go to GM for this, as they'll sell you the same known defective switch. Go to some place like Rockauto.com, or autozone, etc and get an aftermarket switch that has had this problem addressed in its design.

You have to bleed it on all 4 wheel

Under the front seats you have wires going to your seat belt anchors.These wires are atached to a sensor witch activate the air bags if the anchors have force pull on them.The wires have plugs under the seat.Disconnect the plugs and spray with electical cleaner and replace.Make sure the ignition is switched off befor you attemt doing.90%of the time this will work.good luck.

hiya if the rear lights are remaining on ? with no ignition it will be the brake lights staying on this is easily remendied/ checked by trypulling the brake pedal up by hand and see if lights go off ? if so then you will need to adjust the b/light switch which is positioned adjacent to pedal and can be screwed inwards towards the pedal untill the plunger on switch is pushed into the switch which puts lights off ensure pedal is fully up then adjust switch reconnect the wire/plug and press pedal slightly to ensure b/lights operate ok and then go off with pedal released ? on hyundai the brakelights do not req ignition on to operate hence more likely problem is as above good luck