Questions & Answers for: brake pedal switch

brake pedal, the brake pedal will move away from the brake light switch and cause a close circuit and the brake lamps light up. There is a rubber bunk on the pedal which pushes against the brake light

Ad

...brake pedal and i notice another switch controlled by the foot pedal. What does this switch control? Thanks. I have a 1999 mercury Villager . I was adjusting the brake light switch by the brake pedal ...

Ad

Question about 1992 Dakota

1 Answer

...brake pedal is stuck and it needs replaced,Its got like a push button setup when you apply the brakes the brake pedal pushes the brake switch button in brake lights come on and when you relase the ...

Question about 1996 Taurus

1 Answer

...brake pedal the car will not shift out of park but teh brake lights turn off??? CHECK BRAKE LIGHT SWITCH TO SEE IF ITS TOUCHING THE BRAKE PEDAL.IF BRAKE LIGHT SWITCH OR BRACKET LOOSE AND AWAY FROM ...

Question about 1988 Dakota

1 Answer

...brake pedal height, and see if pulling up on the pedal gets rid of the brake lights staying on. Maybe the lines have to be bled to get rid of air in the brake lines. Or, the rear brakes should be ...

brake pedal....at the top under the dash a switch attached to the pedal brake pedal switch spring is hooked it might have came of or might need adjustment counterclockwise in the adjustment.adjust and

Question about 1997 Bravada

2 Answers

...brake pedal arm. It has voltage going to it, and when you depress the brake pedal, the switch closes and let the voltage go to the brake lights. (These switches are adjustable) BRAKE SWITCH IS A ...

...Brake Pedal Position) switch. Brake Pedal Position (BPP) Switch Removal & Installation To Remove: Disconnect battery negative cable. Disconnect brake pedal position (BPP) switch electrical ...

Question about 2002 A4

1 Answer

brake pedal down a few inches, then pull the switch plunger rod out of the switch toward the brake pedal arm, as far as you can without using excessive force. Next, return the brake pedal to the pedal

Question about 2001 Aztek

4 Answers

...brake pedal arm is.the brake light switch is loose or broken.or bracket holding brake light switch is loose or broken fell out of position. the brake light switch suppose to be touching the brake ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...