How to reset abs light 95 gmc Sierra km 4x4 - 1995 GMC Sierra

Doing a brake job has nothing to do with the ABS system .There are three or four wheel speed sensors , depending on the type system . A EBCM - electronic brake control module controls the system .An if the light is on there is DTC - diagnostic trouble code stored in the EBCM ! A diagnostic tool that can read these codes has to be hooked up the vehicle to see what code is stored an then diagnosed . If you are unfamiliar with this your best bet would be to take your vehicle to a qualified repair shop . There is no just turning it off .

See u-tube under bad auto ground. Test with volt meter. Locate cables from ground side of battery to body, take off and clean.

sounds like a bad ground connection.. find and secure all you can and reboot...good luck

gmc envoy i had done the same wound up replacing all four wheel brake pads and light stayed off

Output speed sensor needs replacing

the leak is probably a separate issue from the noise. is the leak very bad? can you tell if it's engine oil or transmission lube/fluid? most likely the rear main bearing seal needs replacing. the noise is most likely the clutch release bearing. you should replace all components of the clutch assembly which include; clutch plate, pressure plate, release bearing and piolot bearing. also have the fly wheel resurfaced. while the trans is out, you can check the rear main seal and the trans input shaft seal and replace accordingly.

yo man, idk if this is exactly what your problem is but my 1991 gmc sierra was doing the same fuckin thing and ****, and i took it to the gm dealer and had them look at it and my connectors and my ignition switchs were fried, also my truck was having a problem shitfing once those went but i also had that problem, perhaps yours is somehwta liek that as well... hope i could help

Wheel speed sensors misadjusted, damaged , or metal shavings and other debree, since they are magnetic can give false readings from one of the wheel circuits. Over sized tires can give of false speed readings as well. there are many other causes including bad relay, control module, e.t.c. It is best to have the proper scan tool to diagnose an ABS problem

Or you could just pull the fuse for the abs and not have abs but you won't wreck from pulsating pedal.

The abs light has to be reset by a scan tool.It should not have come on unless the new wheel speed sensor is faulty or you forgot to plug it back in or you turned the key on while the sensor was unpluged.Double check your work before having it reset.Good Luck!!!!!