Where does the inertia switch located on 2000 gmc sierra 4.3 liter

SOURCE: how to replace a water pump on a 5.3 liter sierra

I suggest that you visit the autozone.com website and register the vehicle. It doesn't cost anything and will give you access to an online repair manual. The steps for replacing the water pump should be available there. Hope this helped and best wishes.

SOURCE: 2000 gmc sierra 1500 5.3 v8. a/c heater control problem

your heat/cool and vent selection options are controlled by engine vacuum through small clear tubes attached to the rear of your climate control interface. Other vehicles have small steel pull wires that operate the desired changes. You might try removing the trim and any fasteners affiliated with the interface/console. GENTLY pull outward and look to see if any of these tubes are pulled off or cut/damaged. Did anyone recently install a new stereo in the vehicle? If so, the vacuum tubing and or pull wires that change your outlets could have been damaged when the stereo unit was pushed into place. Hope this helps

Testimonial: "Very good information. THANKS!"

ZJ Limited

• 17989 Answers
• Posted on Mar 17, 2010

SOURCE: how to pullout starter on 2000 gmc sierra 4 by 4

4.3L Engine

1. Remove or disconnect the following:
   
   Negative battery cable Bracket and shield Wires Mounting bolts and shims Starter

1. Install or connect the following:
   
   Starter Mounting bolts and shim. Torque the bolts to 33 ft lbs. (45 Nm). Wires. Torque battery wire nut to 89 inch lbs. (10 Nm) and ignition nut to 18 inch lbs. (2 Nm). Bracket and shield. Torque the nuts to 53 inch lbs. (6 Nm). Negative battery cable
   
   
   Fig. Exploded view of the starter motor-4.3L engines.
   
   

1. Remove or disconnect the following:
   
   Negative battery cable Bracket and shield Wires Mounting bolts and shims Starter

SOURCE: 2004 gmc sierra 1500 blower motor location

The blower motor is on the passengers side under the dash.You might have to remove the a lower panel.This is the insulator panel.If the blower works at all just turn it on and follow the noise.Hope this helps.Good luck.

SOURCE: How do i put a new ac belt on for a 2000 gmc

Hello, this is the instructions for replacing the a/c belt.

Remove the A/C drive belt.