None of my dash gauges are working how can I fix my problem

None of my gauges will work, but my turn signal indicators ...

www.americanautowire.com/.../none-of-my-gauges-will-work-but-my-tu...

None of my gauges will work, but my turn signal indicators, high beam ... As we've discussed previously, anything electrical needs a 12 volt feed and ground to work. ... 09/28/2015 There are a number of new products coming in Nov/Dec this ...

my gauges quit working - CarGurus

www.cargurus.com > Questions > Ford > F-250 Super Duty

CarGurusSep 21, 2013 - my gauges quit working - My odometer, speedometer, fuel, tach, trip, and ... I tried fixing the wire and had the same problem....so I replaced the shift lever and everything is back to ... no gauges will work in dashboard 1 answer.

No dash gauges, but dash lights - Car Forums and Automotive Chat ...

www.automotiveforums.com > ... > Dodge > Caravan ' Voyager

Feb 6, 2010 - The dash lights work fine, so does everything else. The dash gaugesjust don't work. This is something that has been an intermittent problem ...

Check fuse for gauges. If ok, try banging on top of dash above instrument panel to see if they begin to work again. If they do, possible loose connection or defective cluster

tap the dash see if it comes back on. if not the control in the dash board may have gone. or push on the dash if it works then its not sitting propper to the plug on the back of the dash.

Go to fuse panel left of steering column. Ck to see if #17, 10A fuse, is blown.

If none of the gauges work, there is a power problem.
The gas tank sender grounds the fuel gauge and the temp sender on the engine block grounds the temp gauge.
Could be a wiring harness issue or a problem with the printed circuit board too.

GM had gauge cluster problems from 2000-2005. Bad stepper motors. On those units you have to replace the cluster or rebuild it with new stepper motors. Dealership fixed mine for $150.00

these jeeps are known to have a faulty ground wire behind the dash that provide all the grounding for the dash functions, put also check all the fuses for a possible simple fix

remove the cluster clean contacts with dielectric spray then apply dielectric grease to connectors and reinstall if this doesnt help you need a cluster

Have the computer checked

to fix the motors to gauges need to be replaced each gauge has one i got mine on ebay is the only fix cost for all motors 35.00 dollars