My clutch is getting stuck and not coming back up when I release it, it's a 2006 Ford Fusion

2006 Ford Fusion Owners Manual - Scribd

https://www.scribd.com/doc/.../2006-Ford-Fusion-Owners-Manual

Mar 10, 2014 - 2006 Ford Fusion Owners Manual - Ebook download as PDF File (.pdf), Text ... To reset the switch, refer to the Fuel pump shut-off switch in the .... Holding the TRIP/RESET button for two seconds or more will reset the trip odometer to zero. .....Turn the ignition switch to RUN and then back to LOCK. rotate the ...

[PDF]Ford Fusion - Dealer e-Process

cdn.dealereprocess.com/cdn/servicemanuals/ford/2006-fusion.pdf
2006 Fusion (fsn) ... well acquainted with your vehicle by reading this handbook. ...Fuel pump shut-off switch: In the event of an accident the ..... reset the trip odometer tozero. ..... Turn the ignition switch to RUN and then back to LOCK. 4.

Key Stuck in Ford Fusion (2006 model) - YouTube

? 1:21
https://www.youtube.com/watch?v=3LVQttFOzGA
Jun 18, 2014 - Uploaded by Jessica East
#Ford #Fusion #Key #ignition #Stuck #FordFusion2006. ... i have a 2006 mercury milan and my key got stuck in there last night,... it to park with a little bit of force. will see what happens next time. good video, nice to know.

Key Stuck in Ignition While in Park

www.2carpros.com/.../2007-ford-fusion-key-stuck-ignition-while-park
Dec 16, 2012 - KEY STUCK IN IGNITION / SHIFTER BINDING CONDITION FORD:2006-2007 Fusion LINCOLN: 2006 Zephyr MERCURY: 2006-2007 Milan

1. Press and release SETUP to display "OIL LIFE ***% HOLD RESET = NEW".
2. Press and hold RESET for two seconds and release. Oil life is set to 100% and "OIL LIFE SET TO 100%" is displayed.

i think you just need a new master cylinder thats all not a big job to change it ,also try squirting the spigot bearing carrier with some engine oil if you get it onto the shaft as the slave cylinder is inside the bell housing on this model andf it could just be that the thrust bearing is sticking to the housing due to wet conditions and dust and dirt inside the bell housing

unless you bought an extended warranty on your car very doubtful that it will be covered. but you can check if it is, get your vin# from driverside door panel or from driverside windsheild at bottom of window. write the vin# down and call the dealership and ask them if you are covered.. hope this helps!!

this may have the ignition key lock deal you push the key in and turn it back then itll release.

thrust bearing thats all .

Take it to the dealer as it is still under warranty.

i read other forums and found out if you remove the ring around the shifter button it releases the key. sometimes this gets stuck and the car thinks it is still in gear so it will not allow the key to release. this worked when it happen to me!

The fuse for the cigarette light is fuse number 15 in the fuse box inside the vehicle. The fuse will be a 20 amp fuse. The fuse panel will be under the dash on the driver side. This will have a cover over it and may take a flashlight to find. Replace the fuse and test to see if its working. If its not check the fuse again. If you find it blown again look for loose change or some conductor stuck in the cigarette lighter. good luck