SOURCE: removing the 2.7 engine from 2001 sebring sedan?
ok heres the simple version its alot of work
remove hood put someplace safe
disconnect all wireing and mark off with masking tape and marker
****** you need car lift ******
remove all plastic part molding from engine
find the engine hoist holes for chain to hook to
this is a unibodi design so the whole front chassis drops down
unbolt the chassis make sure to have the chasis blocked and stable
lift car while chasis stays on floor engine tranny and every thing inside hood comes down on the unibody this is how you remove an engine from a sebring
or you take to the dealer spend the doe cause you got a nice car and have it done right
SOURCE: no power to cigarette lighter, and no fuses
Did you check the fuses under the hood? The cigarette lighter fuse is not located in the fuse box by the passenger door.
SOURCE: Where is the fuel filter located on a 2004 Chrysler Sebring Sedan
Some of the Sebrings have two filters(one is called a sock).The sock(which all sebrings have) is located in the fuel tank itself on the pump module.If this model is the JXI then the external filter is located on the belly of the car between the tank and drivers rear seat. I hope I could help!!!
SOURCE: Need to know how to replace Blower motor and
Go to this link for detailed info on replacing blower motor resistor for '02 Sebring ... part looks different for the '99, but instructions are the same.
http://www.automotivehelper.com/topic294308.htm
49 views
Usually answered in minutes!
×