SOURCE: Flasher Relay location- 1998 Mazda B3000 pickup 4x4
it's basically a stand alone relay... most times... look for a relay by itself and often round. my ford winstars flasher relay was actually located in the fuse box under the drivers side dash. it was blue and larger then the other relays so that may be a clue to you.
Robert
Please take a moment to rate this solution
SOURCE: Location of signal flasher relay on '02 Ranger
The hazard switch is the flasher for both the turn signals and the hazard lites Sometimes when it fails to work dancing on it ( quick jabs on and off makes it work again but not long. The dealer has them call the parts dept as all Ford dealers are connected as for in stock for ford parts Lincoln. Have your VIN in hand to read off as they will like you more and can give you better service. the reistration has the number your insurance card has the number looking thought the windsheild at the drivers side pillar has the number on top of the dash. Its also on the end of the drivers door it starts with 1 and is the longest number on the sticker. The dealer parts person can usally find all he can with the last 8 didgets
SOURCE: where is the flasher relay located for 1998 Toyota 4- Runner
Toyota Pick-ups, Land Cruiser, and 4 Runner 1997-00
Flashers -REPLACEMENT
The turn signal flasher
is usually located in the convenience center, under the dash, on the
left side kick panel. In all cases, replacement is made by unplugging
the old unit and plugging in a new one.
Hope helped with this (remember rated this help) Good luck.
SOURCE: 1998 Dodge Durango flasher relays location
Turn on the Durango and check each of the four turn signals
to make sure that the bulbs are not burned out. If you find one that has gone
out, replace the bulb and retest the turn signals. When a bulb goes bad on this
circuit, the resulting operation can mimic a bad flasher or one that is
failing. Locate the combination turn signal flasher and relay. It is
on the left end of the driver's dash. Open the access door and view the
collection of relays and fuses. At the left side of the mounting block is a
larger flasher and relay. This is the combination turn signal flasher and
relay. Test
the relay by placing you finger on the relay housing and activating the turn
signal. If you have found the right one, you should feel a clicking as the turn
signal blinks. Remove the relay, replace with the new relay and close the
access door . Start
the Durango and activate the turn signals to check that they each work. The
light should turn on and should blink. Also, check the hazard lights to make
sure they work.
321 views
Usually answered in minutes!
×