Drivers Side Door Handle

Search Results

How To Install Replace Inside Door Handle Chevy Equinox ...

? 9:02
https://www.youtube.com/watch?v=cY6asyM2R6g
Feb 2, 2012 - Uploaded by 1A Auto Parts
How To Install Replace Inside Door Handle Chevy Equinox 05-09 1AAuto.com .... found your tutorial on fixing my driver's side door handle for my 2006 Equinox. .... Door Handles Chevy Equinox 2010 2011 2012 GMC Terrain ...

How To Install Replace Inside Door Handle 2007-13 ...

? 9:05
https://www.youtube.com/watch?v=QonKLwhk2CE
Apr 2, 2015 - Uploaded by 1A Auto Parts
http://www.1aauto.com/interior-door-handle-driver-side-front/i/1adhi00417 1A Auto shows you how to repair, install, fix,change or replace a broken or snappe... ... 10, 11, 12, 13 Chevy Silverado, Tahoe, Suburban and GMC Sierra, Yukon Denali ...2007-2011 Tahoe Yukon Suburban Escalade Vent Section ...Missing: terrain

How To Install Remove Rear Outside Door Handle 2007-13 ...

? 10:02
https://www.youtube.com/watch?v=7ZUTqqEzpZg

should be a plastic clip to pop it into

Remove the inner door panel & replace the handle

Dealer parts counter or salvage yard

there is a locking C clip between the handle and the door panel were the handle pivots on the regulator shaft.there is a thin plastic spacer that keeps the handle from rubbing on the door panel and sometimes the clip is between it and the handle.there is a tool specially for this but you can use a flat bladed screw driver and push the clip off of the handle groove that it sits in.then you can remove the handle.

you need to remove the inner door panel.you will have to look for the screws holding the panel on at the arm rest area and behind the door handle.were the door lock lever is you will have to remove the plastic cover.then if you have power windows its easier as you don`t have to remove window handle,if its manual windows then there is a clip that must be removed to remove the handle,its located between the handle and the door panel and usually faces the handle knob,push the clip off of the handle.then you will have to go around the edge of the panel along the side and bottom and pull outward to disconnect the push in clips from the door.then move the panel to remove it from the door(may have to disconnect wire connectors).then in the upper right area of the inner door panel the bolts will be visible,make sure window is up.remove bolts and electrical wires if power mirrors and remove the mirror.install in reverse order.

There are two screws holding the plastic trim panel. Take off the panel and you will see where the handle is attached to a linkage. Remove the retaining clip and replace the handle.

Sounds like the latch is in the closed position. does it bounce back open? Its like a hook latch, pull the door handle to open it and at same time pull the latch out. And it should move out and leave it open for the pin to go into it.

There are two screws under a cover at the bottom of your inside door handle and on your door latch. Other then that snap all the fasteners free from the door before you pull the panel, oh and have some silicon to re attach the plastic vapor to the door. Good luck

u r asking 2 different things if u are working on a gm pick up as they r seperate items... door handle is bolted in, lock uses a clip... remove door panel!

remove the clip... first remove the door panel.