SOURCE: How to remove the inside left side front door
Snap out two door pull strap retaining screw covers. Remove screws.
Remove screws on front, rear and center of front door trim panel.
Using the Trim Pad Removing Tool or equivalent, pry the trim panel retaining clips from the door inner panel.
These are plastic so be careful you can use a pair of needle nose pliers if you don't have a trim tool.Just start at bottom of door panel and work your way around and up.
SOURCE: Lincoln Town Car 1999 driver side window switch
I have the same problem in my 2001 towncar. I removed the switch control panel (without removing the door panel) by prying up from the front of the panel. There's a spring loaded plug under the mirror adjustment. Once you get that pulled up, the whole unit will lift out. Since there's a two year difference in the models - it MAY not work... however, you might not have to remove the whole door panel as you think.
In my case, the wiring was bad.
SOURCE: 2003 Lincoln Town Car - Power window switch removal/installation
SECTION 501-05: Interior Trim and Ornamentation
2003 Town Car Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 01/28/2002
Front Door Trim Panel Printable View (206 KB)
Removal and Installation
NOTE: LH side shown, RH side similar.
Open the screw covers.
SOURCE: How to remove front dopr
Front Door Panel - Town Car - Removal
CAUTION: To avoid breakage of door pull cover(s), insert a screwdriver
diagonally between pull strap and chrome bracket. Snap out both sides
then remove.
Snap out two door pull strap retaining screw covers. Remove screws.
Remove two screws on front and rear side of front door trim panel.
The following procedure must be used during removal and installation of
the door armrest and trim panel. Refer to the appropriate illustrations
for component and vehicle model identification.
Using the Trim Pad Removing Tool from Rotunda Windshield and
Moulding/Trim Removal Kit 107-R0401 or equivalent, pry the trim panel
retaining clips from the door inner panel.
NOTE: Do not use front door trim panel (23942) to remove trim clips from
door inner panel. Replace any bent, damaged or missing push pins.
Remove window regulator control switch housing from back of front door
trim panel . Lift up housing, remove retaining screws and disconnect all
connectors.
Disconnect driver seat regulator control processor switch (driver door
only) if equipped.
Twist out interior lamp wire assembly and remove the front door trim
panel.
Installation
Ensure plastic watershield is secured to door panel.
Position front door trim panel to door. Connect interior lamp wiring.
Position the window regulator control switch housing and connect switch
connectors. Install the retaining screws.
Connect driver seat regulator control processor (14C708) (driver door
only) if equipped.
Align door lock side to its mating slide on the sheet metal (front doors
only).
Snap in front door trim panel. Ensure all retainers fit properly.
Install two retaining screws on front and rear side of front door trim
panel .
Install two retaining screws and pull strap covers.
Good luck Remember rated this).
SOURCE: How do you change the door hinge pin? On 1997 lincoln town car?
Well cracklin joe half the hinge us welded to the door..Duh!
1,453 views
Usually answered in minutes!
×