Describe where the crank censor is on a 02 Hyundai santa fe 2.7
SOURCE: My 02 Hyundai santa fe
I'm not sure if this has anything to do with your problem.. but in 2002 there was a recall on the 01 & 02 santa fe's w/ the 2.7L engine for improperly manufactured crankshaft position sensors and internal gaps within the cases allowing epoxy to contact the printed circuil board, which resulted in cracking of the printed circuit board capacitor. A damaged capacitor could result in engine stalling. Recall campaign number 03V030000
SOURCE: Fog Light Replacement Hyundai Santa Fe
The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.
SOURCE: PROGRAM KEYFOB FOR HYUNDAI SANTA FE
This is from the factory service manual of your car:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Translation you need the dealer to do this.
SOURCE: 02 Hyundai Santa Fe 2.4 Timing Marks?
dear friend-CA2 and CA1 will point to the top.OPwill be 5 two and CS will be 10 two and BS will be 15 two check rotation of belt(arrow)if this does not make sense plse contact me.
021 556 2752 or 084 549 1998
SOURCE: Change serpentine belt 2004 Hyundai Santa Fe
it uses a spring loaded tensioner.use a breaker bar to rotate the tension and it should just come off.if u need a pic or anything else to do it let me know,
481 views
Usually answered in minutes!
×