Replace rear window motor in 1995 ford taurus

SOURCE: 1995 Ford Taurus brake pad replacement

the piston need to be turn clock wise and push at the same time make sure when you turn it the rubber around the piston dont get damaged it stick to the piston and get torn before you turn just make sure it not sticking to the piston at the auto part store they sell the toll to turn the piston its cheap$$ hope it FIXYA our post thanks pierre

SOURCE: I have a Ford Taurus 2003 SES that needs new front and rear strut

you will need sockets and a socket wrench, a screwdriver, jacks and jack stands, and a set of combination wrenches.

also this site should help, it's a very thorough step by step on strut removal

SOURCE: ignition switch in a 1995 ford taurus

Ignition Lock Cylinder
Ford Taurus/Sable 1986-1995 Repair Information





REMOVAL & INSTALLATION

Functional Lock


The following procedure applies to vehicles that have functional lock cylinders. Such cylinders either have a key available or known key numbers from which a key can be made.

1. Disconnect the negative battery cable.
   
2. Turn the lock cylinder key to the RUN position.
   
3. Using a 1/8 in. (3mm) diameter wire pin or a small drift, depress the lock cylinder retaining pin through the access hole in the upper steering column shroud (under the ignition lock cylinder) while pulling out on the lock cylinder. Remove the lock cylinder from the column.
   

1. Install the lock cylinder by turning it to the RUN position and depressing the retaining pin. Insert the lock cylinder into its housing. Make sure the cylinder is fully seated and aligned in the interlocking washer before turning the key to the OFF position. This will permit the cylinder retaining pin to extend into the cylinder housing.
   
2. Rotate the lock cylinder using the lock cylinder key, to ensure correct mechanical operation in all positions.
   
3. Connect the negative battery cable.
   

SOURCE: where is the a/c low side service port for 1995 Ford Taurus

Locaed on the bulkhead on the passangers side. A plastic shield runs along the top of the bulkhead hald by three plastic clips and screws. remove this and you will see the connector port.

Johnny Brown

• 5763 Answers
• Posted on Jan 19, 2010

SOURCE: 1994 ford taurus rear speakers replacement

you have to remove the seat, remove the lower part first, it snaps in, then remove top part of seat, then you will see the pop in fasteners that hold the rear deck. if you have a problem go to this web site it will help with step by step instrucations. hope this is helpful. chttp://www.crutchfield.