Why speedometer and rpm starts jumping after switching on the engine
SOURCE: How do i remove my immobileiser? from my 1996 Subaru Legacy GTB
the alarm turned off as soon as you unlock the door with the key... the clicking noise could just be the fact that your battery is dead. hope i was some help
SOURCE: 1996 Subaru Legacy No Power At All
Last night I checked the battery and it was still good. I disconnected and then reconn ected both terminals and that brought the power back. When I turned the key the power went out again. I repeated the procedure but did not turn the key. Instead, I took off the knee bolster and tried to wiggle the wires under the dash to see if I could find the source since it seems to be related to the ignition. Nothing cut the power so I started it up and it worked fine except for the check engine light which was flashing that says I have a misfire condition. I drove the car 25 miles to work this morning and will be taking it to the dealer for a better inspection.
SOURCE: Electrical Problem with 1999 Subaru Legacy
hi there, your alternator is not putting out enough, subbies should put out about 14.4v and just after starting should put out 40-60amps. charge the batt that is in it now with a small (3.5-6amp) charger overnight then start the car and LOAD TEST the batt and alternator at a battery shop. ask them to put a carbon pile load tester on your system. im pretty sure they're gonna tell you its the alternator. many thanks, hope this helps!
SOURCE: 1999 Subaru Legacy Sedan.. speedometer works
I finally fixed mine, on my 1999 Subaru legacy 30th anniv edition. . .
I removed the speedometer head, and resoldered the green connector on the board. Then I also ran a wire to duplicate the trace wire from the middle pin to the first connect (about 4mm). Problem gone.
email for more details if interested: mike(at)whiteley.org
295 views
Usually answered in minutes!
×