Remove trunk liner cadillac sts - 2002 Cadillac Deville

Looking for location of Maxi Fuses on 1997 Cadillac STS

Depending on what you are looking for ... it might be under the hood or accessed from the trunk.

If this answer comes with 3 links ... just look at the last one (Looking for location of Maxi Fuses on 1997 Cad STS)

The fuse is located under the rear seat in the fuse box.Trunk/valet fuse.

remove the push pins from frt inner fender liner and the splash shield on bottom so you can bend plastic liner back far enough to get your hand inside to where the bulb is rotate it and remove from socket and reverse process

Trunk liner has to be lossened and pulled away
Front lamp assy removed
Crawl under car for fog lamp

Open the trunk and carefully pull off the trunk lid carpet liner by working at each black push-pin. They will be tight, so confine your pulling to as close to each as possible. Using a deepwell 10mm socket, remove the 11 (?) nut washers on the studs holding the license plate and lamp assembly onto the trunk lid. Carefully remove the entire license plate/lamp assembly. You can remove the sockets and harness if desired.

You will need to replace ALL the bulbs - why go through this again ?? You'll need 4 each #194 (tag/running lights), 4 each #3457, and 2 each 2357.

The OEM bulbs are #3057 and #1157, but the new numbers are slightly brighter. Don't worry about the backup lamp bulbs being dual-filament: the wedge base will always align the correct filaments in the socket.

Now place a dab of flexible duct seal (hardware store) around each stud base. Carefully push the assembly back into place, and using an assistant, check the operation of all circuits. OK ?? replace all the nut washers, snugging them up in a center to outside sequence to spread the loads - don't tighten each one all the way the first time - work around and around 3 times.

If you still have a bulb out or dim bulbs, then check the wire harness where it exits the left trunk hinge rail and also the harness ground at the sheet metal at the left fenderwell.
Read more at http://www.cadillacforums.com/forums/cadillac-seville-cadillac-eldorado-forum/194807-2001-sts-reverse-lights-replacement-how.html?kcplink=1Read more at http://www.cadillacforums.com/forums/cadillac-seville-cadillac-eldorado-forum/194807-2001-sts-reverse-lights-replacement-how.html?kcplink=1

open trunk, remove the plastic panel around the latch plate, remove the plastic mounting bolts that hold the grey trunk liners in place, there are two 10mm nuts that hold in the light remove nuts pull out light twist the bulb retainer out and replace bulb.

Two hour job in your driveway. Lift the side needing replaced, remove plastic clips and wheel liner. Unbolt bumper face, starting from the wheelwell and working in. If repacing the passanger side, remove the bolts holding the fuse box inside the engine compartment to allow for more room. The replace is made through the wheelwell.  

Two hour job in your driveway. Lift the side needing replaced, remove plastic clips and the wheel liner. Unbolt the bumper face starting from the wheelwell and working in. When replacing the passanger side, remove the bolts holding the fuse box in place and move to allow more room. the replace is made through the wheelwell reaching in.

the fuse is in the fuse box in the trunk and it is a 10amp fuse marked body2

on my 1998 Deville its located in the trunk. the panel thats is butted up to the back of the rear seat. look for some black nuts around the top of rim of the trunk, they are about 1'' long, these have to be removed first... good luck.....

Mac.........