I need to replace the arm on the exterior mirror
SOURCE: REPLACE SIGNAL BULB
You need a small flat screw driver and look at the back side the outer edge and push in and slowly pop out it has little dimples to keep it in. and if you need a mirror lens i hate to to tell you this you can try keystone automotive in the yellow pages it may be the cheaper but I would get one from Mercedes if need any more help go to collisionrepairadvice.com
SOURCE: How do i fit a replacement nearside wing mirror
You'll need a screw driver (philips is most common), a plastic prying lever, socket (should be 10mm, but can't remember)
If you're lucky, on the inside of the door, will be a triangular panel
right behind the mirror that you can pop off. If you're not as lucky
and it's one piece or the panel is blocked by the door panel, you'll
need to remove the door panel to change it.
On the inside trim,
you can remove screws (these screws may be covered by filler pieces or
may be visible, or they may require you pry a plastic piece off that
covers the screws) that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls. Then you can remove the bolts
holding the mirror onto the door
SOURCE: mercedes w210 2001 wing mirror dissmantel to
Hi, Fold mirror in towards car and you will see an inspection hole at the bottom left of the end of the mirror housing. Insert a flat blade screwdriver into the hole and press against a small metal clip. you will feel the clip move and the housing will then slide off allowing you to unclip the glass
102 views
Usually answered in minutes!
×