1998 Chevrolet Metro Logo

Related Topics:

t
tedp Posted on Mar 12, 2014

98 chevy metro service engine light, same as check engine...sensors or what?

5 Related Answers

Anonymous

  • 1118 Answers
  • Posted on Mar 28, 2009

SOURCE: need to clear service engine soon light on a 98

Take it to auto zone, they will turn it off for you, or any auto parts store will do it. Or you can try unhooking the NEG. battery cable for a few minutes and then hook it back up and see if it don't go off then. Just make sure you unhook the NEG. NOT POS.

Ad

Anonymous

  • 10 Answers
  • Posted on Mar 28, 2009

SOURCE: reset compter

disconnect the batterey for a few minutes and that will reset your light. If it immediately comes back on then you may have an open short.

Anonymous

  • 135 Answers
  • Posted on Jun 17, 2009

SOURCE: 2001venture van service engine soon light stays on

most any sensor going bad can cause the check engine light to come on,try disconnecting the posative battery cable for 15 seconds ,then put it back on,will reset the codes, or take it to auto zone,they will test your computer for codes at no charge to you.i had a venture van my was ox. sensor. thanks robert b.

Anonymous

  • 32 Answers
  • Posted on Sep 21, 2009

SOURCE: po452 trouble code changed sensor engine light

you might try unhooking the battiey for 20min both + and - posties cuz that will force the computor to have to resest only if you have addressied the fuel pressure problem which taht would most likly be your filter which isn't all that much

roniecon

Ronny Bennett Sr.

  • 6988 Answers
  • Posted on Jan 19, 2010

SOURCE: 1999 Chevy Metro 1.0 L OBDII CODE P420. NEW O2

The o2 is just reporting information,it did not mean that it was bad,there is either restriction,in the cat,or there is a contamination in the fuel,an additive might clear it up,maybe.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1998 Chevy Metro ck engine light on what is the code P0135 mean

Code P0135 means ... O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 1)
In the exhaust system there are sensors to test the oxygen level in the exhaust gases from the engine. These have a heating wire built into them.
Yours is reading as faulty. They are positioned before and after the catalytic converter in the exhaust. This code refers to the one nearest to the engine. You will probably need to replace the whole O2 sensor, ( sometimes called a Lambda sensor).
1helpful
1answer

98 Chevy metro regular headlights don't work but high beams do, suggestions?

I have seen both low beam bulbs burn out at the same time.
Its possible the relays have burnt out for the low beams.
0helpful
1answer

How to check engine codes on 98 chevy metro?

take it to parts store and they will do it for free
0helpful
1answer
0helpful
1answer

Ok my chevy metro lsi is misfiring not sure which cylinder but it is misfiring and causing the service engine light to stay on how do i fix this

Possible bad plug, if coated with oil, then you might have other issues there. the engine light goes on cause the not firing cylinder is making your oxygen sensosr kick the light on.
Have plug, wires, and coil checked, replace as needed.
0helpful
1answer

I HAVE A 2001 CHEVY GEO METRO. HOW DO I RESET THE SERVICE ENGINE LIGHT?

take it to your local auto parts store, they will read the code then clear the check engine light
0helpful
1answer

Locating camshaft sensor in 1996 geo metro

So what engine is in it? It always helps to state which engine you have, trans, 4 door ect. Should be near the harmonic balancer either attatched to ther front of the engine, or bolted to the engine block.
0helpful
1answer

1999 Chevy Metro 1.0 L OBDII CODE P420. NEW O2

The o2 is just reporting information,it did not mean that it was bad,there is either restriction,in the cat,or there is a contamination in the fuel,an additive might clear it up,maybe.
0helpful
1answer

My chevy metro 98 1.3L starts perfect but it does

can be a number of things from fuel pump to coil pack but check the egr valve may be starting to go -remove and check for carbon build up if not fully encrusted use a carb/or a carbon cleaning solution to clean and free up valve--most problems give a code but -fuel pump-filter-air filter dont and egr will sometimes set off other sensors but usually doesnt until its to late
0helpful
1answer

1998 Chevrolet Metro engine fails

is your check engine light on? If so, have it read from a neighborhood store (i.e. Checker, Autozone), they tend to do it for free. That will give you the reading on what it is. You may also want to take a look at your MAS air flow sensor. It will allow you to start your vehicle but will tell the engine that it is gasping for air and will shut down. (That is usually connected right after your air filter)
Not finding what you are looking for?

374 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...