SOURCE: how do you replace the distributor on an 89 jeep
Jeep Wrangler/YJ 1987-1995 Repair Guide
DISTRIBUITOR
REMOVAL & INSTALLATION
2.5L Engine
1987-90 VEHICLES
See Figures 1, 2, 3 and 4
Fig. 1: Exploded view of the distributor-1987-90 2.5L engine
Fig. 2: Positioning the oil pump shaft for distributor installation-1987-90 2.5L engine
Fig. 3: Positioning the distributor rotor and shaft for installation-1987-90 2.5L engine
Fig. 4: Rotor position with the distributor properly installed-1987-90 2.5L engine
The wire connector will contain a special conductive grease. Do not
remove it. The same grease will also be found on the metal parts of the
rotor.
To install, if engine was not disturbed:
If the engine was turned while the distributor was removed, or
if the marks were not drawn, it will be necessary to initially time the
engine. Follow the procedure below.
To install, if engine was disturbed:
Remember rated this post; I hope help you with this.
Testimonial: "Extremely helpful!"
SOURCE: caster adjustment for 1990 jeep yj wrangler
caster is adjusted at the rear of the lower control arms. Camber is fixed and cannot be adjusted by normal means (though special off-set ball joints are available to do that) Toe in is adjusted by turning the sleeves in or out on the tie rod ends. None of this should be done at home though crude adjustments can be made in order to get the front end reasonably straight. Adjustments are made on an alignment machine that allows precise adjustments to all you mentioned as well as front/rear tracking.
1,022 views
Usually answered in minutes!
Hi Bridget Espitia, I want to help you with your problem, but I need more information from you. Can you please add details in the comment box? Which motor is in the jeep? What electrical issue are you tracing?
×