VW POlo tdi 14. when engine goes at cruising speed of about 120 kmh it loose it s strenght and have to switch off ignition and start again to get normal power. what do you think is the fault?
SOURCE: VW Polo Map sensor fault code idling pooly
Hi, I have a 2001 polo 1.4 mpi it lackes power when you hit a hill it just dies, It has had new cat, fuel filter, fuel pump and throttle body, but is still the same it just dose not want to give me full rev's?
SOURCE: 1992 VW Polo 1.3L Coupe: warning light mystery
Polo Coupe 1043,1992, Will not start, can be bumped started, sometimes!!, theres a strange clicking noise from under the air box, when the ignition is on and sometimes the oil pressure light comes on when the car gets upto temperature, then I lose all power and then the engine cuts out. I've recently changed the dizzy cap, rotor arm and battery, all the leads are new ish along with the spark plugs. The previous owner has changed the head and done all that, leaving much of the engine loom unlagged and bare. Could this cause a problem on some of the electrical systems?
SOURCE: MY VW POLO SHOWS FAULT CODE ; P0106 ABSOLUTE MANIFOLD PRESSURE SE
this a map sensor, probably just need the sensor replaced, it measurese intake vaccum and adjusts air/fuel mixture accordingly
Testimonial: "MANY THANKS TO HONDABOY 47. SPOT - ON. PROBLEM SOLVED!"
SOURCE: I need to replace the rear brake pads on my Polo 1.9 TDi
this is a turn in caliper, meaning that as you try to compress the piston, you also need to rotate it clockwise. you can buy tool for this at nearly any parts store, and is fairly inexpensive.
Testimonial: "Thank you for your assistance. I found out the turning piston part by mistake, a day after I posted the question, when I tried to use a G-Clamp."
SOURCE: 2002 VW Polo - EPC Light and Loss of Power
Hi,
It is a wiring fault, but they are looking on the wrong end. You will need to have a VW dealer "repin" the electrical connector at the throttle body. What this means is, the dealer will take apart the connector, cut off the old pins and crimp on new ones and reassemble the connector. This is a common problem on drive by wire VW's. The dealer has a bulletin on the problem and I don't know why they missed it. They will probably have to order the connector kit however. Good luck!
255 views
Usually answered in minutes!
×