Toyota camry problems

Alan Conner

• 359 Answers
• Posted on Mar 08, 2009

SOURCE: toyota camry 1997 3.0 v-6 code p0446

That code is for the evaporative emmisions system. Here is a link to an open forum you can go to, this will help you understand what it is, and why. The vehicle on the site is a van, but the code, and parts involved are one in the same, so don't worry about the difference in vehicle. The van is a toyota, and this is the information on the p0446 code. Hope this helps you.
http://steampunkworkshop.com/toyota-sienna-evaporative-canister-and-svs-valve-repair

SOURCE: 1997 Camry Power issues

Please take the car for diagnosis. Or replace all the fuses.

SOURCE: reverse suddenly quit 95 toyota camry 4cyl auto

Check your transmission fluid level asap. if the level is good, you will need to inspect the shift solenoids located inside the transmission pan. replace any solenoids that are proven to be faulty. i would also advise to test the pcm/tcm for its operational value as well. this device controls the shifting patterns of the auto trans.

while checking the solenoids, if you notice any metal fragments on the bottom of the pan, this will be a sign of major gear friction. you should re build in this case.

SOURCE: 1995 Toyota Camry 4 cylinder runs hot

Hi,

Firstly, ensure you have the required 'mixture' of coolant/water (must have required coolant).

Second, I would recommend you re-test all the cooling system sensors again (make sure they're within specifications), in case a new one is faulty.

Third, ensure the new thermostat was of the correct temp setting (they all differ), so that it opens at the required time. Most cooling systems operate within 90 - 100degC.

Fourth, make sure the radiator (and associated hoses) aren't blocked.

If your temp gauge is reading higher than normal, but NOT in the danger zone...then this can be considered normal (especially if you've replaced with new components) and nothing to be concerned about.

However, if the temp gauge IS in the danger zone....then this suggests the coolant is not flowing through the cooling system properly.

If all above components test ok, then it's possible your water pump may not be pumping enough volume.

Cheers,

Testimonial: "I appreciate your help...Maybe I should just relace the water pump, that would be the last thing that I would need to replace."

SOURCE: 1997 camry, speedometer quit, power windows quit

You must have a sensor out somewhere. This sensor must be the same one controlling your speedometer and also helping your tranny shift properly.