1999 RR HSE when DS door opens no dome light, Pass side make dome light come on. Also want to change to LED lights, suggestions!

REPLACE THAT DOOR SWITCH SEBO.

hi jerome
I have the procedure for Toyota auto lock, is worth to try it
AUTOMATIC LOCK SETTING
1) Step in the vehicle and make sure that all doors are closed completely
2) Insert the key into the ignition key cylinder.
3) Wait for more than 5 seconds.
4) After turning the key to the ACC position, turn the key from the ACC to the
ON position 5 times within 10 seconds (Last position : ON).
? Status Monitor LED will illuminate for 30 seconds.
Note : In case you implement 6 times or more by mistake,
action steps 6)-8) you made will be canceled.
Please retry from step 2).
5) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key to the ACC position.
? LED will continue illuminating.
? Indicator lights will flash 2 times.
Ignition controlled door lock ON :
6) While the LED is illuminated:
• Open and close the driver's door 1 time.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 1 time.
? LED will extinguish.
Ignition controlled door lock OFF :
6) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 2 times.
? LED will extinguish.

If the other side lights work fine, i suggest check bulbs and replaced.

Hope helps.

the switch in the door is grounding out causing light to stay on replace switch

Negative from the dome light to one terminal on the door jab,and the other terminal,hook to,and run to the other door jam on passengers side.The hot wire from the dome light goes to the hot side on the fuse box.A additional light switch can be installed,to turn the dome light on from inside the car,by running a ground to the switch,and from the switch to the ground side of the dome light.

Check fuse 23, 27 and 33 inside the vehicle. Chances are you blew a fuse when the dome lamp shorted. The modules should be okay.

unfortunately the switch is part of the door latch and more than likely is your problem.

Faulty switch.Change.

12 volts
black/light blue stripe wire runs up passenger side A pillar.

check that the buttons on the doors are not stuck or broken.. you also have a dome override (should be near your light switch) or the roller that dimes the interior lights