Size wrench oil drain plug hyundai - Accent Hyundai Cars & Trucks

Here's a link to your drain plug,it says to use a 15 mm wrench or socket.

You only need a few. You need a wrench or socket that fits the oil pan drain plug. Car makers have used all sizes of drain plugs, don't know Saturn's, anywhere from 13 millimeter to 19 millimeter size wrench or socket. One of them will fit yours.
So one wrench (when you find the right one) and you will need a drain pan to catch the oil. Next you will need an oil filter wrench or tool. There are several types and sizes-when you buy the new oil filter you can get the filter remover that fits your filter . A parts person should be able to help you select the right one. Also buy a small funnel to pour new oil into the engine .And don't forget to have a few rags handy to clean up spills and wipe off areas. That's about all that is normally required.

Place container under oil drain plug under the engine oil pan, remove drain plug using 17mm socket or wrench.

Hope this tip helps.

r/
David

The oil pan drain plug should require a 14mm hex head wrench to remove. The transmission pan requires a 10mm allen head socket, or wrench to remove. Are you sure you're trying to remove the correct drain? The oil drain should be on the passenger side and on the rear corner of the pan.

crensant wrench sould do it it adj in size

The oil drain plug is located on the bottom of the oil pan, under the truck. The plug size if metric, 15 mm.
Good luck.
Regards,

Lift your Hyundai Santa Fe using a jack and then place the car on jack stands. If you don't have jack stands, drive the car onto a set of wheel ramps.
Pop the hood and remove the dipstick and oil filler cap. The dipstick is near the front engine compartment with the oil filler nearby.
Gather an oil drip pan, a 17-mm wrench, oil filter wrench, cleaning cloths and a new oil filter. Slide under your Santa Fe.

Change the Oil

• Locate the oil filter and oil drain plug underneath the car. The drain plug is on the bottom of the oil pan, and the filter is to the side of the oil pan.
• Remove the oil drain plug using the 17mm wrench. Pull the plug out quickly and let the oil drain for 10 to 15 minutes. Check the gaskets and threads for damage. Replace these components, if necessary.
• Take off the oil filter using an oil filter wrench. Dump the old oil into the oil drip pan and put on the new oil filter. Tighten the oil filter by hand, and then replace the oil drain plug using the wrench. Clean off the excess oil.
• Go under the hood and add oil. Turn on the engine and check the oil pressure gauge to make sure it rises. Let your Santa Fe run for a minute.
• Lower your Hyundai Santa Fe and turn off the engine. Take an oil reading on the dipstick. If the oil level isn't at full, add a bit more oil.

Thanks
Kinldy rate the answer
Smith

The drain plug is on the oil pan, bottom of engine. Use an adjustable wrench

the engine takes 4qts w/filter and the drain plug is 17mm.

it is very easy to change the oil put the car on ramps secure the back end look for the drain plug underneath the engine make sure you have the right size wrench and when you remove the plug also check the gasket on the plug to make sure it is not cracked you will also need an oil filter wrench and my other suggestion to you is to go to autozone to see if they have a Haynes repair manual for your car and if they don't see if they can order you one in the mean time they can also print you off a diagram of how to change the oil in you car safely