I'm starting to put back together my 1991 Lexus ls400 transmission Im changing the torque converter and seal . Do I have to fill the converter up with oil before I put it on the transmission?
SOURCE: R & R 1991 Lexus Ls400 Gear shift knob
slide the lower part of shifter handle down and you will find two screws, but there is 2 wires coming in from center console for overdrive button.you have to remove the center console cover and remove the 2 wires from connector and then pull up threw handle.when you go back together you will have to guide them back threw the handle.
SOURCE: Changing 1996 Lexus LS400 headlight bulb.
you have to remove the head lamp. there are 4 bolts that hold it in. you will have to remove ouyer marker lens first.1 screw on top and pull forward. clips hold lens pretty tight.
SOURCE: Transmission Leak. Torque Converter Front Seal?
I know that GM dosen't have a fill/check tube on several models. They use a plug on the side of the unit (like on stickshift transmissions) I'm sure there would be a similar item on your transmission otherwise after a rebuild, there would be no way to refill it. If it's a small leak you could try using a good sealer/conditioner such as Lucas, which may help you a lot.
SOURCE: Replace/fix starter on 1991 Lexus LS400
Not too bad. Not much room, just enough to drop the starter. It is probably easier to go up through exhaust if you can get your exhaust shield off the manifold .
SOURCE: how to change the fuel pump on 1991 lexus ls400
remove rear seat then remove cover in the trunk, you will see a cover remove thatcover and remove 8 bolts holding fuelpump in tank,also dissconnect connector to fuelpump with bolts removed the pump pulls right out.hope this helps.
246 views
Usually answered in minutes!
×