Locating and replacing a camshaft sensor in a 2005 dodge neon

P0315 - Crankshaft Position System Variation Not Learned
P0335 - Magnetic Crankshaft Position Sensor Electrical Error China OBD2 car diagnostic tools wholesale on CareUCar

http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?fromSearchPage=true&pageId=0996b43f81277ec7&partName=Camshaft+Position+Sensor&partId=0996b43f81277ec7 Here's a link on how.

its located at the end of the camshaft, (drivers end) at the cylinder head. easy to replace. once you have the new one in your hand, you will see it.

Hello alantrou
The cam sensor is located on the back of the head(transmission end)
Hope this helps.

Removal & Installation 2.0L engine camshaft position sensor location

2.4L engine camshaft position sensor location

2.0L SOHC Engine To Remove:

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Remove or disconnect the following:
   • Brake booster hose and electrical connector from holders on end of cylinder head cover and reposition
   • Electrical connectors from camshaft position sensor
   • Camshaft position sensor mounting screws
   • Sensor

To Install:

1. Install or connect the following:
   • Camshaft position sensor. Torque sensor mounting screws to 80 in. Lbs. (9 Nm)
   • Brake booster hose and electrical harness in holders on end of valve cover
   • Electrical connectors to camshaft position sensor

2.4L Turbo Engine To Remove:

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Remove or disconnect the following:
   • Air cleaner box
   • Plastic clip for the wiring harness from the stud on the valve cover
   • Nut holding the clip for the oil supply line to the turbo and disconnect the fresh air makeup hose from the valve cover
   • Electrical connectors from camshaft position sensor
   • Camshaft position sensor mounting screws
3. Remove sensor

To Install:

1. Install or connect the following:
   • Camshaft position sensor torque sensor mounting screws to 80 in. lbs. (9 Nm)
   • Electrical connectors to camshaft position sensor
   • Nut holding the clip for the oil supply line to the turbo and disconnect the fresh air makeup hose to the valve cover
   • Plastic clip for the wiring harness to the stud on the valve cover
   • Air cleaner box
   • Negative battery cable

if your standing in front of the car facing the engine. It's on the right side behind the rear of the head. It's square with 4 10mm bolts and a plug in thats a pain to get unpluged sometimes.

should be located on one side and below the valve cover near the very front or the very rear of the engine... these things are easy to point out then to try and describe... hope that gives you a starting point

cheers

try autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

camshaft sensor located on end of cylinder head near battery..remove battery..4 bolts and wire connector..clean mounting surface and install new sensor

Had the same problem before on my 04 Neon SXT...camshaft sensor is on left side of engine block, take out the battery and to the left of it (face car) is the camshaft position sensor. To change it you'll have to move a few hoses but its plan to see there on the left side of the engine...pretty easy remove and replace. Fixed my problem of car not going above 2k RPM when i replaced the sensor.