Replacing 2004 cavalier crank sensor, i can't locate the best way to replace it. need a diagram or where i can find it.

On your intake manifold, #3 in diagram. My info showed two wires, one is gray, the other is orange with black tracer.

is it a no crank or crank no start?
Possible causes for code P0335
- Faulty crankshaft position sensor
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery

Read more: http://engine-codes.com/p0335.html#ixzz3Cxw6SN6O

Engine diagram for 1996 chevrolet cavalier 2.4L. This is a sample for an 1996 2.4L engine schematic...

can u show me a diagram where the crank position sensor is on a 2002 cavalier 2.2

You will need to replace the fuse located underneath the drivers side steering wheel. Flip the fuse box cover lid over and you will find a diagram showing where the heater blower motor fan is located. Pull the fuse out and replace it with the same number fuse.

U uvicasion del crank shaft position sensor

on a 2-2 remove starter motor. disconnect sensor wiring,remove crankshaft mounting bolt and take out crank sensor. the sensor is located by the oil filter. as for the camshaft sensor, (the 2-2 is not equipped with a camshaft sensor)

Try this.

The crank sensor is under the oil sending unit on the back of the motor next to the firewall. It is held in the block by an 8mm bolt. It has to be removed from under the car. Get under the car on the RH side and get back far enough that you can see over the transaxle. Good Luck.

Haynes Manual at library or local dealer can copy it for you