How do I get at the right front signal light bulb. I cannot find a way to reach up from underneath or down from the top to get the bulb out. Does the lens snap off from outside?
Thank you for your assistance.
Garry Miller
Calgary AB Canada
There are 2 bolts on the top corners of the bulb lens that needs to be removed then the lens pops right out and you can change the bulb.
I can reach up from underneath, I had to pull on the plastic a little to get my arm up in there on the far right side below the bumper, then unscrew the bulb fixtur a 1/4 turn ccw and the bulb and wire will pull out and drop down so you can replace the bulb then stick your arm back up and put the bulb fixture back in by turning it 1/4 turn cw
How to change the right front turn signal bulb on a 2005 Ponitac van.
1,786 views
Usually answered in minutes!
There are no bolts through the lens. And there does not appear to be enough room from behind to remove the bulb. Cannot get a hand near the light.
Sorry for the bad score but it is exactly what you earned. THERE ARE NO SCEWS THROUGH THE LENS.I found out from another source that you have to remove the headlamp assembly and then it is easy to get at the signal bulb. I have replaced the bulb. I am sorry you had to be sarcastic with your reply and I hope you will learn that sarcasm gets you nowhere and usualy backfires as it did this time.
Garry
I suspect you are not a qualified auto technician.
I suggest you do not give advise until you learn more about automobiles and courtesy.
×