20 Most Recent 2006 Pontiac Montana Questions & Answers

This should help:

Question edited for clarity. Question moved to model category. Air bags only deploy if there is weight on the seat. Yes they are removable.

Pontiac Montana SV6: how to remove second row seats ...

JustAnswer https://www.justanswer.com > Pontiac Problems Apr 21, 2015 - HI, Attached at bottom of the answer is directions to remove the seats - below is procedure to disable airbags before beginning work ... 1 answer · Top answer: HI, You can but you have to know the resistance of the airbags, which unfortunately gm doesnt ...

Removing The Bucket Seats - Pontiac Montana SV6 2008 ...

ManualsLib https://www.manualslib.com > ... > Owner's manual 1. Pull the nylon strap or lift the recline lever. · 2. Press back on the seatback until it is in the desired. position · 3. Let go of the strap or lever.

Removing Third Row Seat From A Pontiac Montana An Easy ...

osvehicle.com https://www.osvehicle.com > removing-third-row-seat-... Mar 29, 2023 - The most straightforward way to move the furthest back seat is to remove it from the back door and slide it out. Uncomplicate The Task: Removing ... ..

which 1 do you need to change/ there is 5 to 7 of them

2004 was the last year for the montana and it was exactly the same as the 2001. In terms of the tilt lever, they were all the same. Just grab it and pull straight out from the column. You can use a screwdriver to pry if its too hard. Utube has several videos demonstrating the technique.

Go to autozone.com and look it up free or manuals.com. Mike

Fix your car right away by clicking the link I attached Pontiac Montana Sv6 Complete Workshop Service Repair Manual 2005 2006 2007...

because of remote start fob needs to be flashed at dealer

I find the best way to replace the belt on any car is to have a piece of paper and draw circles where each pulley would be and draw a yourself a picture where the belt would run up and over or down and under. Never fails for me. Do not take your belt off before you draw yourself a picture.

Did it blow heat before?

Might have a door switch bad is bad or wiring to one of the switches. I would begin by checking if there are any blown fuses. Would then check wiring to each door, along frame inside a rubber boot where door hinges are. If wiring is all good, I'd then move on to removing door panels and disconnecting each door latch harness until the chime goes off. This will indicate the specific switch that is bad. If all are good.

Below is a picture of the ignition coil, connected to the coil are spark plug wires, follow those wires from the coil to the end, at the end you will find the spark plug wire connected to the spark plug which is screwed into the cylinder head of the engine, there are 6 spark plugs.

This can be caused by the combination switch, pull the airbag (disarm first) and steering wheel then the sitch and test it. Since GM uses the same basic switch on all models it builds you could try a cheap used one.

Get someone with electrical knowledge and a tester to check the supply etc to the fan. Also the switch if the rear is separate.

There are 2 bolts on the top corners of the bulb lens that needs to be removed then the lens pops right out and you can change the bulb.

Fuel pump, maybe? If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_3e83613ef5f2a68b