SOURCE: 2003 GMC Sierra heater Blower wont shut off
My 2003 Sierra's blower came on by itself in the garage while I was sleeping and ran the battery completely down. I had to replace the blower switch located under the glove box next to the blower at the bottom of the right corner of the dash. The switch is in front of the blower and held in by two screws. Disconnect the two wire connections. This is a "dealer only" part and cost me 65.00. Also check the wire harness with seven wires connected to it for melted plastic. It will be marked "ABCDEFG". If it has melted, you'll need to replace it. Pay attention when reinstalling either part, that the wires "ABCDEFG" match the switch in that order.
SOURCE: I need to remove the
What's the problem? Do you need to know where the screws are, what tool you need to remove the manual crank handle or pry off plastic retainer clips? You remove all the screws you can see including the armrest screws. And either ask for the right tools at a auto parts store or try using a couple of screw drivers. The window cranks are sometimes held on with a screw or nut under a plastic cover on the crank handle, but most use a C clip or wire clip that fits in a groove in the back of the handle between the door pannel and crank.
SOURCE: 96 gmc sierra hard to crank after 12-14 hours
that has a votec engine in it the fuel pressure is droping at knight and it takes 60 psi before the injectors will fire most likely cause fuel pump ,leaking injector ,or a feul pressure regulator
SOURCE: Rear-end grinding noise in 1993 GMC Sierra 1500
your description sounds like the gears inside the the same differential you just replaced.
SOURCE: 91 GMC G2500 5.7L 350 Stalling when warm
You should try looking at the transmission fluide, it must be short. If it is, you should go buy a transmission fluid. And make sure you car pipes has no leak.
61 views
Usually answered in minutes!
×