Headlight adjustment How do I adjust the headlights on my 2000 Mitsubishi Montero Limted Sport

Follow the link
2000 2006 Mitsubishi Montero Headlight Bulb Change Replacement

Stop by an Autozone...they should should be able to get a print out of the head light wiring diagram for you.

are they adjustable shocks

http://www.ehow.co.uk/how_6696609_montero-sport-headlight-removal-instructions.html

I need to change the headlight on the left side on my Mitsubishi montero sport 2000 can you help me

Hello, are you changing the whole headlight assembly or the bulb? Let me know I can help you out!

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

USE LARGE PLIERS AND TURN SLOWLY LEFTY LOO SEE.

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

You have to squeeze the connector... there is a plastic lever as part of the connector, which has a barb on it. You must squeeze the lever, thereby releasing the barb and allowing you to slide the connector off the bulb prongs.