Cars & Trucks Logo

Related Topics:

Lance Elder Posted on Jul 09, 2013

My 96 Chevy blazer won't accept gas every time I

1 Answer

A

Anonymous

Codes or no Evap Codes, the issue is in that system
You need a schematic of the evap system, so you can
test the solenoid or valves,mainly the vent solenoid, if that
applies Not the purge valve, that is up front & opens to allow
engine vacuum to draw out fuel fumes from the tank.

5 Related Answers

SCOTT OCONNOR

  • 169 Answers
  • Posted on Aug 26, 2008

SOURCE: '96 Regal Purge Canister Valve?

ADAM
THE PURGE SOLANOID IS ON THE ENGINE WITH A RED CONNECTOR ON IT. IT IS LOCATED ON THE REAR OF THE ENGINE ABOVE THE REAR VALVECOVER. YOU ARE ACTUALLY LOOKING FOR THE CANISTER VENT SOLANOID AND IT IS IN THE REAR OF THE CAR AND THEY FAIL OFTEN. GET THE PART FROM G.M. AND THEY CAN TELL YOU EXACTLY WHERE IT IS. THE G.M. PART IS UNDER $30.00.

Ad

Anonymous

  • 37 Answers
  • Posted on Mar 19, 2009

SOURCE: Mustang GT 4.6 EVAP Canister Purge Valve Location?

You will need to remove the right front wheel & wheel well liner. The canister purge valve is behind the cover. It should have two tube going into the bottom and one on the side near the top.
You can fix it!
If this helps you out please rate me!
Brett

Anonymous

  • 102 Answers
  • Posted on May 18, 2009

SOURCE: '96 Chevy Monte Carlo- codes P0441 and P1655

it will be the evap solenoid that will be the problem,not sure where it is in that car, sorry

scott

  • 532 Answers
  • Posted on Oct 24, 2009

SOURCE: I need to locate the canister purge valve and the

look above the spare tire under the back of the box

Anonymous

  • 37 Answers
  • Posted on Oct 19, 2010

SOURCE: 2004 Chevy Cavalier 2.2 eco Automatic 94,000 miles

in my experience the usual culprit is the evap cannister. the problem is it gets moisture in it and freezes during winter thus cracking the plastic. if you lay under the car and look at the evap box it black plastic and if you see a loose or cracked hose or the box itself is cracked that is most likely it. as a side note you can check the gas cap and buy a new one to see if that rectifies the situation. lastly i don't think the gas tank should be suspect as you would probably notice if gas was leaking out of the tank. if you take the car to a dealer or shop they can do a smoke test and determine where the leak is.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Fuel pump in 96 Chevy Blazer replaced by mechanic, gas gauge didn't work after, took back, gas gauge only goes halfway now. What is causing this and what is remedy?

incorrectly and half assed installed. putting a fuel pump in a chevy is very difficult and takes patients. most mechanics dont have that so go to another shop and make sure they fix the problem before you pay.
0helpful
1answer

96 chevy blazer won't start.

your gas pump is maybe your problem
1helpful
1answer

96 chevy blazer won't start.

I'm following another issue like this on a 1996 Jimmy.
This engine requires 60psi or more fuel pressure to run.
You need to have someone check the fuel pressure at the rail- throttle body with a gauge.
2helpful
1answer

How do you clear code P0440 after you change gas cap

if the gas cap was the problem it will clear it self in a week or two .Or you could take to the auto parts store and they will do it for free .You need need a reader or scaner to clear it I also have a 96 chevy and get this code from time to time it means that there is a small leak someware in the EVAP system or some times it sets off falsey . This system runs 8 differant self tests everytime you start the vehicle . But P0440 isn't a code to worry to much about it won't damage your vehicle in any way
0helpful
1answer

I have a 96 Chevy Corsica and it won't start.... I

If you have a healthy spark (a blue snapping spark), it would not be a problem in the ignition system or the module. An orange, weak, or intermittent spark could point to trouble in the ignition.
I would check the timing on it, maybe it is a timing chain problem. It should have fired and ran a bit with the starter fluid. The fact that it didn't, even with a good spark, well, probably needs a little shop time investigating. Jumped timing from a worn chain? Low compression in one or more cylinders? A couple of things you need to consider.
Good luck.
0helpful
1answer

Will a throttle position sensor cause my 96 model Chevy blazer 4.3L vortec get bad gas mileage I'm only getting 225 miles to a full tank

I would replace both o2 sensors and take the mass air flow sensor off and clean it with a non-chlroated brake cleaner.Also a tune-up sure won't hurt sparkplugs,plug wires,distributor cap and rotor.Your fuel milage should increase.
0helpful
1answer

My 1996 chevy blazer won't start. we changed the the fuel pump, fuel pump filter checked the relay and she turns over once we put gas in the carb. body. help please

Have you ever put in the gasoline tank any injector cleaner yet because the cleaner will unclog the injectors so full amounts of gasoline can get into the piston chambers the right amounts so try putting injector cleaner into your gas tank. When you put this into the gas tank to remember that it takes time for the cleaner to get to the injectors so you might have to keep trying to start the vehicle many times for the cleaner to unclog the injectors. This will not hurt your vehicle at all so go try this.
0helpful
2answers

1996 Chevy Blazer won't start unless i add gas to the carb. Turns over fine but won't start.

You could try changeing the fuel filter its located under the drivers door mounted to the frame in the fuel line . But the most likely thing that it could be is the fuel pump. You could check fuse # 9 its a 20 AMP in the fuse box that feeds the relay located in the glove box but on this vehicle even if the relay wore bad the vehicle would still start it would just crank for a longer time . the fuel pump has a beck up power supply also feed from fuse #9 that runs through the oil pressure sending unit. So if its not the fuse its the pump or a bad connection at the pump and that is located inside the fuel tank witch needs to be droped to replace the fuel pumpGood luck with it but this is a common issue with blazers
0helpful
2answers

Chevy blazer wont start 2002

if it turns over there are a cocuple of things to check. crankshaft sensor and the coil pack maybe the computer.id start with the crankshaft sensor
Not finding what you are looking for?

230 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...