Need to know how to change dash bulbs ,
SOURCE: The dash light will not come on in my 2003 Ford Escape
CHECK FOR FUSES IN OWNER MANUAL,SHOULD BE 2 BULBS SO THEY COULDNT WENT OUT SAME TIME.
SOURCE: How do i change a motor mount in a 1993 ford taurus?
The engine mounts (2) and the transmission mount serve to hold the drive train compontents in the chassis and do so flexibly and with the strength exceeding the torque generated by the engine. If not for the mounts, when opening the throttle (in gear), the engine and transmission would lurch out of the engine compartment!
Check the mounts by raising the hood and, with the engine running, holding the brake firmly with one foot, select drive or reverse, briefly accellerate while holding the brake firmly--observe while doing this the engine will rise slightly (good) to a couple of inches (not good). Do not let the car move, nor let anyone stand in the car's path were it to move. Accellerate for not more than two seconds when checking the mounts.
To change them you need to raise the car and safely support on jackstands under the side rail of the car in the indicated position. I have been able to do this raising only the passenger side.
Then you will need to carefully lift the engine, too. I have used a hydralic "bottle Jack" placed under the block at the edge of the oil pan.
Using 18mm wrenches loosen the nuts at the top and bottom of the mounts. I change one mount at a time. Remove the nutsand the the worn mount (careful- it's fluid filled-- nasty stuff, you would not like spilling it on yourself).
You may have to lift the engine quite high and wiggle the mount around to clear getting it out and the new one in. Orient the mount correctly so that the tabs fit the slots, start the nuts on the studs carefully, you don't want these cross threaded, then tighten completely, having lowered the engine fully onto the new mount first.
Check the new mount as described above.
Be very careful in doing all of this. Use tire chalks, set the parking brake. Check that the car is secure on the stands prior to getting under it. Use common sense too.
SOURCE: Where is the Fan Relay Switch located on a 1993 Ford Taurus 3.8 V
It is inside the that box on top of radiator with large wire plug. it cannot be replaced by itself. You must replace the whole unit.
237 views
Usually answered in minutes!
×