Oil Indicator error light on

When you say the "oil light," do you mean the light that says "Change oil" or are you seeing the red light that indicates low oil pressure?

If you're seeing that red light, that likely means you have low oil pressure and should stop driving immediately, until the problem is diagnosed and repaired.

It's also possible to see the oil pressure light on when there's no issue with oil pressure, if the oil pressure sender has failed or there's a connection problem.

If the oil light you're referring to is the "change oil" light, you will need to manually reset it for it to disappear. Here's how (from Chrysler):

1. Turn the ignition switch to the ON/RUN position (do not start the engine).
2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you start the engine, the oil change indicator system did not reset. If necessary, repeat these steps.

use menu on on indicator stalk to call up engine oil life this is sometimes indicated as a oil can [sorry forgot to mention ignition on ,engine not running] press set /clear button on end of indicator stalk and hold until it beeps [5 secs aprox]..this will reset it ,but it is normal for the warning light to stay on for afew days until it disappears ,the oil life should 100%.

1. Turn the ignition switch to the ON (II) position.
2. Press the Select/Reset knob repeatedly until the engine oil life indicator is displayed.
3. Press the Select/Reset knob for more than 10 seconds. The engine oil life indicator and the maintenance item code(s) will blink.
4. Press the Select/Reset knob for more than 5 seconds. The maintenance items code(s) will disappear, and the engine oil life will reset to 1OO.

Sounds like your either low on oil - or - your oil pump has seen it's days.

how many miles?

The fuse number is

#16 - 5 Amp (Tan)

Gauges & Indicator Lights: Low Oil Light, Low Washer Light, Service Reminder Light, Transmission Oil Light, Brake Warning Light, Anti-Lock Brake Warning Light, Fuel Pacer Light, 4WD Indicator Light, Malfunction Indicator Light, Warning Buzzer, Overdrive Switch (1992-93); Transmission Oil Temperature Lamp, 4WD Lamp, Overdrive Module Seat Belt Warning Buzzer
(1994-95).

Hi , is the colour of the warning light red or yellow, red would be for oil pressure , yellow would be for oil level , but you may find that the oil level sensor has become faulty, reagrds mark

I would go back to Walmart and have them fix it for free. I suspect it's a bad oil filter. If you hear engine knocking or noise, don't drive vehicle.

These old models of Fox's are just that old. I have been told that the engine light goes on due to the lack of oil pressure in the car. The valves apparently get worn out and create a lower pressure that the oil will pass through them...therefore sometimes this registers as an engine light going off every now and again. However, my mechanic has told me that these old german cars are like tanks and can run on and on and on....on lesser than normal oil pressure in the engine. Keep it well maintained and watch for any abnormal or steady warning lights. My mechanic says don't take the car any farther away than I would chance a tow ride back. If that is a hint or what! Lol.

I believe that's the low beam headlight indicator. The circle w/ lines going to on side is the highbeam indicator. You can download your owners manual from Toyota.

that sounds like its not a oil level gauge at all. it sounds like a oil psi indicator. when you accelerate your oil psi increases. same when the engine is cold. this is a normal thing that trucks and every vehicle for that matter do. my truck has a oil psi indicator and it does exactly what yours does.