Looking for fuse for abs on 2000 jetta not working.fuse side drivers door good

SOURCE: passenger seat heater not working in my 2003 volkswagen jetta

There are different fuses. check your fuses properly.

rate this fixya

SOURCE: door panel

here is a diagram of how to unistall your door panel. please do not forget to rate and comment about your experience with fixya today.

Driver's Side Door
NOTE This procedure is for models with power windows. If equipped with manual windows, refer to the procedure for the Passenger Side Door Panel.


NOTE Do not grasp in grip depression when pulling off grip recess, as there is a strut secured to door trim underneath.

1. If necessary, make sure you have the radio code.
   
2. Make sure the ignition if OFF, then disconnect the negative battery cable.
   
3. Insert a suitable prytool in lower partition between the panel and grip recess.
   Insert a suitable prytool in lower partition between the panel (1) and grip recess (2)
   
4. Unclip the grip recess upward out of door trim. Do NOT reach into grip depression while doing so, to prevent damage to brace.
   
5. Press the locking lug against the connector (3 – arrow) and pull it off.
   Unclip the grip recess (2) upward out of door trim. Do NOT reach into grip depression while doing so, to prevent damage to brace (1). Then , press the locking lug against the connector (3 – arrow) and pull it off
   
6. Unscrew the 7 mounting bolts.
   
7. Unclip the door trim at the sides using disassembly pliers 3392, or equivalent.
   
8. Lift the door trim up out of window recess.
   Unfasten the 7 bolts (arrows). Use pliers to unclip the door trim (1) at the sides, then lift the trim up out of the window recess
   
9. Unclip the cable guide using a prytool, pull out the bracket in the direction of the arrow, then unhook the cable hook.
   Unclip the cable guide (1) using a prytool (2), pull out the bracket (3) in the direction of the arrow, then unhook the cable hook (4)
   
10. Disconnect the connectors and remove the trim panel from the vehicle.
    View of the driver’s side door panel—with power windows
    

1. Pull off the window recess seal from door trim and insert in window recess.
   Pull off the window recess seal (1) from door trim and insert in window recess
   
2. The remainder of installation is the reverse of the removal procedure, noting the following:
   
   • Before installing door trim, check all clips and replace as necessary, and insert into mounts of door trim.
     
   • After connecting battery, check that the vehicle equipment (radio, clock, electric windows) is operating properly.
     
   • If the Electronic Control Module (ECM) is subject to low voltage with ignition on, DTC memory and Readiness code must be checked with a scan tool.
     

SOURCE: how do i remove drivers side door panel that has

theres a clip behind the crank handle pop it with a screwdriver and pull handle.

SOURCE: 1999 passat v-6 abs,brake lite come on,oil lite

A friend of mine has a VW Sharan V6 that done almost the same things and it was the electric water pump on the front bottom right of the engine that seezed up( yours is most likely doing the same), it's a black cylindrical sausage shape but a little thicker in size.The water leeks into the motor when it seezes and causes a intermittent short circut.

Ronny Bennett Sr.

• 6988 Answers
• Posted on May 04, 2010

SOURCE: brake lights are out both sides only center works.

Check the brake light switch,and look for a brake light relay.