I had the wheel bearing replaced on a saab since then the abs & the srs lights are on.
SOURCE: 1999 saab 9-3 wheel bearing removal
You need air tools, many differnet size sockets and a press. The strut/spindle and lower control arm have to come out all together. leaving the axle in the car.The spinlde cannot be removed from the strut. once removed, you can then unbolt the lower control arm ball joint nut, and seperate the lower control from the spindle - for ease for the press. press the hub out, remove the snap rings on either side and press the old bearing out. press in new bearing , install snap rings, press the hub in and reinstall. I just did one today... I have 15 years experience as a ford tech - Ugh bro.. - Josh
SOURCE: turning off service light on saab 93
Hi,If you press and hold the reset button on the SID unit the message will go out ,however it might come back on a few times so you may have to repeat this for a couple of days till it stays out.
SOURCE: headlight replacement 2000 Saab 93
To replace the headlamp on a Saab 9-3, open the hood. Behind the
headlamp there is a round black plastic cover; screw clockwise and pull
back; there is a metal clip holding headlamp in place (9003 i believe
is the halogen number). locate top of clip and move very slightly
clockwise; the top will pivot down on a hinge; release the wire harness
and pull out bulb. Retrace these steps to introduce the new bulb to
your Saab.
Hope this helps. Please leave a rating! FIXYA!
SOURCE: how to bypass the turbo on my saab 93 2.2 tid
No you can't.Internal damage will be done to the engine.Sorry to tell you this.
SOURCE: 2003 Saab 9-5 tail lights out. Replaced bulb no
Saabs are finicky here. Try replacing all your tail lights at once and use bulb grease to help insure a good connection between the bulb and the socket.
143 views
Usually answered in minutes!
×