For the past 2 months I have been having problems with my trunk opening. Please help me.
TRUNK WILL NOT OPEN It
can be trunk cable issue or the latch issue which gets open/close. It has to be
inspected. ========= There
are few relatively helps links with solutions to troubleshoot these problems.
--------- I
suggest you to go through the links and confirm the issue: ------ Click
the link below: ---- http://schematicsdiagram.blogspot.in/2012/02/trunk-release-problem-on-toyota-camry.html ----------- http://schematicsdiagram.blogspot.com/2011/12/trunk-button-not-working-on-buick-car.html ---------- http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-trunkhatch-lock-on-acura.html ------------- http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-trunk-lid-on-acura.html ----------- http://howtobyme.blogspot.in/2012/05/2005-lexus-sc430-retractable-hard-top.html ------------- http://technoanswers.blogspot.in/2012/04/2000-toyota-camry-trunk-will-not-open.html ------------ These
will help. Thanks.
Trunk release Problem on
Toyota Camry?
Trunk button Not Working on
Buick car?
How to remove Trunk/Hatch
Lock on Acura?
How to Remove Trunk Lid on
Acura Integra?
2005 Lexus SC430:
Retractable hard top will not come down and Trunk will not open?
2000 Toyota Camry: Trunk will not
Open?
SOURCE: 2003 Saturn ION 2 trunk Problem
there is a manual switch that is located near the trunk latch for a safty lockout it might have been switched by accident look to make sure.hope this helps.
SOURCE: Saturn Aura 2007 Rear Brakes
The trick is to remove the cap on the brake fluid reservoir on the firewall under the hood before squeezing the caliper. Be sure to replace the cap before attempting to press the brake pedal.
SOURCE: Reset Oil Change on Aura
turn key on
hold down info and enter buttons on steering wheel at the same time for 5 sec.
odometer will read oil reset
press the enter button until it reads "acknowledged"
SOURCE: Hi! My name is Sharon
Hi, the key fob has contacts on a circuit board, much like a remote control for a tv, or a calculator. These contacts are what the buttons touch, to make it work. the buttons, or contacts may be dirty, with a carbon film on them causing the two buttons not to work, leaving only 1 functional. If you take it apart, much like putting a new battery in, you can actually pop out the green circuit board, and see the contacts. These can be cleaned with a pencil eraser. Try cleaning the contacts, and the back side of the buttons. A re program is not in order, because you have 1 function, and will either work as a whole, or none at all. If cleaning does not work, You may need a new fob. Good luck...coop442000
Testimonial: "Thank you, I did what you have instructed me to do with regard to cleaning the contacts with a pencil eraser. All but one still doesn't work. "
SOURCE: 2009 saturn aura headlight replacement
Please don't kill the messenger, but this is not an easy procedure as access to change the headlamp bulbs is through the wheel well. The recommended method is to remove the front tire and then the plastic inner fender liner. Once removed, you'll have easy (more or less) access to the rear of the headlamp housing.
3,920 views
Usually answered in minutes!
×