I had this problem with my car. Is ur hazzard flasher working? if they are working and the turn signals are not working. Try replacing the hazzard light switch. If the hazzard are not working then the combination flasher unit is bad. its what controls the signals and flasher.
SOURCE: 99 nissan sentra headlamp - hi beam low beam issues
could be the switch. did you do anything to the switch when you changedheadlamps? maybe you put the lamp in incorrectly also did the brights work on the lamp that was "burned out"?
SOURCE: Nissan Sentra License Plate Light Not Working
the license plate because of its position gets a lot of dirt and water problems so i would go back and take another good look remove the bulbs again and see if you can clean the inside with a little sand paper or a little scrape with a small screwdriver then spray with a little sileacone oil replace bulbs.Then switch lights on they should be ok if not try moveing them slightly with your fingers they should light.please let me know how you get on.adrian
SOURCE: 1999 nissan sentra gxe headlight problem
do you have the right light bulb? i own a 98 sentre and
it takes a 9004 bulb, but walmarts computer said to use 9007. That made the high beam censor stay on till i replaced it. if you look at the bulb you can tell if it is a dual or single beam bulb.!!!!
SOURCE: 1999 Nissan Altima GXE Turn signal problem
you have a busted bulb, your hazard may be working fine but the bulb is double contact so one part is working and the other is not. just check which bulb is busted.
SOURCE: 1999 nissan sentra gxe headlight problem
I switched one of the new bulbs with a working older bulb, and the problem went away. weird...
410 views
Usually answered in minutes!
×