SOURCE: honda prelude 1992 i have
try checking the timing...take the valve cover off...remove the rubber cover for your inspection window on the flywheel... line up the white line on your flywheel with the pointer...once your lined up at tdc with the flywheel check your cam sprockets and make sure they are in the right alignment...also take your cap off and look at where your rotor is pointing..making sure it is pointing at #1 cylinder
SOURCE: don't know where to put transmission fuel for a 1988 honda prelude si manual
dont put any fuel in any transmission
229 views
Usually answered in minutes!
tried, repaced ecu crank sensor checked ignition replaced all the fuses
please help i need this car
Mr. Abrahamson, check if the fuel pump is working,when turning the switch on you should hear the fuel pump buzing , if is not check the fuel relay or renew the pump.. If the pump is ok then you should check the fuel filter if is not bloged, and then check if power goes to the injection system. Then you go back for spark. check whether the distributor receive power from coil or not. If coil does not send any then replace the coil. but if it does then go further to the distributor if it gets in and doesnt do output,remove the distributor cap and check if it has any crack or internal damage in the center wher is a carbon and possible worn or broken. If are all ok,check the rotor if is serviceable and not burnt or broken or even more if is turning on crank start. if it doesnt turn,check if the distributor shaft is snapped or broken on the gear part with the camshaft.
fuel pump doesnt turn on checked all my plugs wires distributor replaced all fuses most relays. i removed the python 660xp alarm from it was that a bad idea? please please please help me
×