Who knows a good land rover repair specialist in virginia beach va...my land rover range wont start it cranks and doesnt starts the dealership is not an option cos am a student.....thanks and greatly need help
Hello
The engine
and automatic transmission in this vehicles drive train
are fully electronically controlled by a computer called the PCM
(Power Train Control Module). Whenever a problem like this occurs the
computer stores a record of the problem (there are of course some
exceptions to this, like the fuel pump, engine coolant temperature
sensor and MAF sensor for instance) in the form of a fault code in
its memory, to read these fault codes you must have the systems
memory scanned with a special tool. Once the fault code(s) are read
you then must perform the appropriate diagnostic testing to find and
resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A
TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR
HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM
SOURCE: online owners manual 2000 land rover range rover hse
Do a serch on Google for RAVE. This is the land rover workshop manuals. The owner manuals are included.
MickyDrew
SOURCE: My P38 Range Rover wont start
Hi Adam,
Bring your vehicle to an auto parts or battery store. Ask if they could perform a 'Load Check' on your battery. This not only checks the voltage, but also the amps, as if it were under the load of turning your engine.
It takes a few seconds and the results are pass or fail. Fail means it's time for a new battery. Pass means we need to look elsewhere.
Comment back the results.
Hope you find this to be very helpful
Mike
SOURCE: Intermitant Starting Fault P38A Range Rover
Has anyone considered the electrical feedback from the climate control fans. Change the pollen filters. Duh, its a ROVER!
SOURCE: Where is the crank position sensor in a 1996 Rang
sensor should be next to harmonic balancer.usually bolted to motor.balancer has fins behind it which run through crank sensor magnets to send signals to onboard computer.ensure to replace as per removal method
SOURCE: 1999 range rover se changed fuel pump, truck still
why you have replaced the Fuel pump? who advised you to do so?
be guided as follow
1. on the Engine Side on the top there is a fuel rail for the injectors. turn the ign. key to the second position (on) and check the valve located on the fuel rail if fuel is coming pressurized and still won't work. then open on of the spark plugs wires and check if spark is there. (Be Careful doing that). if no spark then is there any message comes up on the Dash? if not messages then you can check the Crank Sensor if no current being generated from the ign. coils.
372 views
Usually answered in minutes!
×