How to replace turn signal switch
SOURCE: replace turn signal switch 1998 chevy lumina
You may look or feel the back side of the steering wheel, looking for 2 screws that hold the airbag to the wheel, these will be internal torq type screws (star) you may have to rotate the steering wheel 90 degrees to access the screws. You should first disable the airbag, by removing the airbag fuse, and or by disconnecting a yellow connector located near the base of the steering column. under the knee bolster.(panel below column). Once the retaining screws are removed, lift bag and disconnect the 2 connector to the airbag, the ground for the horn, and the horn contact wire, which requires you to push down and twist counter clockwise, damage to the horn contact ring will occur if you try and just pull connector from the ring. Now you can remove the steering wheel, may require a puller, and the you will have access to the turn signal switch.
SOURCE: Turn signal on 97 Lumina not working
Yep ,sounds lke the switch.and yes on the air bag,no big deal.pull the air bag fuse (or better still the battery) wait 15 min then pull the bag . Just unbolts like a horn button.Pull it out and unhook the yellow lead to the clock spring. GM uses a retention clip on the airbag connector,just slide the little clip out then the connector is normal.Place the bag soft side down while it's out.Have to be sure not to turn the wheel once you start the project.
There is a clock like spring that is for the air bag. If it turns too far the spring will break and the bag will not work.As you remove the yellow clock spring it will lock itself,don't push on the lock button,it will spin around inside and break.
A few special tools involved for a clip on the steering shaft and pulling the wheel ,bet the parts store will rent 'em tho
SOURCE: brake wiring diagram chevy lumina
why not just replace the turn signal switch must faster and safer . buy one from your local parts house then you can see its not that easy to install but you can do it with a little help
SOURCE: how replace turn signal switch 2000 chevy blazer?
Since the 2000 chevy blazer is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.
SOURCE: cannot find the turn signal flasher
where is the signal light flasher located on a 1996 chevy lumina
736 views
Usually answered in minutes!
×