1= Universal joints or yokes, or drivesshaft splines are worn.
2) driveshaft is bent
3)engine or transmission, or center driveshaft nager might be loose or worn.
God bless you
SOURCE: jeep won't go over 60 mph loss of power
Check for a clogged catalytic conveter or weak fuel pump. Remove the O2 sensor so exhaust can flow out hole and test drive it. If it's better replace the cat or look for kinked or dented section of the exhaust. If it didn't help, have the fuel pressure tested as well as the ignition advance and timing chain.
SOURCE: overhead console completely dead 2002 jeep grand cherokee laradeo
Check the fuses for the overhead console, could be that if not then the console needs to be replaced.....
SOURCE: Vibration while accelerating from 30 to 45 mph Jeep GrandCherokee
Not a tune up problem,
You need to have all U-joints checked out,They will give you the vibrations only while acceleration
Testimonial: "Perfect, Wasn't sure if it was the right solution but I got them fixed and problem stopped. Thanks."
SOURCE: Jeep Grand Cherokee 2003 vibrations at 30 mph to
One possible cause is a worn universal joint. The first symptoms are usually a powertrain vibration at a certain rpm or speed. A visual inspection will sometimes show powdery residue by one of the bearing caps.
Testimonial: "Perfect solution. Took it into the shop and found 3 bad UV-Joints. Axle almost feel out. Got them fixed and the vibrations and noises stopped. Thanks."
SOURCE: where is the sunroof motor located on a 1997 jeep
Usually right behind the overhead control panel.
361 views
Usually answered in minutes!
×