What is the capasty of r134a gas for seat toledo 2006

wont reset until repair have problem with throttle body position sensor /circuit repair problem https://repairpal.com/obd-ii-code-p0121 https://www.yourmechanic.com/article/p0121-obd-ii-trouble-code-tps-a-circuit-range-performance-problem-by-jay-safford

how to, ? (you meant filler pipes)?

no problem told just a question fully covered in the service manual
no country told, tank parts are not the same world wide (laws etc)
first tell what's up first.
fails smog tests (station)
leaks diesel fuel?
PCM OBD2 vent errors DTC scanned. scan it yet?
at gas fill up the gas blows back on to face? vents failing.
"the short-lived 2.8 L VM Motori turbo diesel (2005-2006 only)"


made here ( ibet all 3 are not the same) nor for all markets exported.

• United States: Toledo, Ohio, (Toledo North Assembly Plant)
• Egypt: Cairo (AAV)[2]
• Venezuela: Valencia, Carabobo

The problem is with corrosion, because seat is not using any lubrication when they fit this sensor to wheel hub. After removing a screw in most of cases you need to destroy old one. But before you replace the sensor check it because some problems with abs are due to connection (wiring) pin outs corrosion or abs control module faults.

You must drop the pan to change the ATF.

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, SRS and BCM faults) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, SRS Supplemental restraint system, BCM Body control module

check the dipstick for the same, if it looks like cottage cheese with oil on it then you are getting coolant in the oil. Many possible answers here: cracked head or block, warped head, bad head gasket. there is also just condensation that too many short trips didn't evaporate.
You don't want to ignore the leak if there is one.

Sorry but This make is not sold in the USA so we have no info on it.

We do not have this make in the US, so we have no info on it. Sorry

check your air flow mass air flow sensor

14mm bolt 100 ft lbs 12mm bolt 80 ft lbs. if you drive real fast on 14mm bolt I like 120ft lbs