20 Most Recent 2006 Seat Toledo 1.6 Questions & Answers

The problem is with corrosion, because seat is not using any lubrication when they fit this sensor to wheel hub. After removing a screw in most of cases you need to destroy old one. But before you replace the sensor check it because some problems with abs are due to connection (wiring) pin outs corrosion or abs control module faults.

check the dipstick for the same, if it looks like cottage cheese with oil on it then you are getting coolant in the oil. Many possible answers here: cracked head or block, warped head, bad head gasket. there is also just condensation that too many short trips didn't evaporate. You don't want to ignore the leak if there is one.

wont reset until repair have problem with throttle body position sensor /circuit repair problem https://repairpal.com/obd-ii-code-p0121 https://www.yourmechanic.com/article/p0121-obd-ii-trouble-code-tps-a-circuit-range-performance-problem-by-jay-safford

Diagramis usually on the inner surface of the fuse box corner and in the handbook

check your bulbs if they went out on or two at a time that would make sense

see gumtree.com

scan car for any codes or unplug computer a few times then see if issue goes--its under the dash or engine area--may need a update on trans-they du a data stream w factory gear to pinpoint problem then download new info

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, SRS and BCM faults) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, SRS Supplemental restraint system, BCM Body control module

Question edited for clarity. There are only a two relays in the box, but not listed for the wiper. This usually means that the wiper is either not covered by a relay or it is a function of the Body Control Module. There are fuses listed.

SEAT Altea (2005-2015) fuses

Fuse Box Diagrams https://fuse-box.info > seat > seat-altea-2005-2015-fuses The fuse box is located in the left side of dash panel, under the steering wheel. The location of the fuses in the ... ..

The diagnostic process for the heating and cooling is a very long and involved process and requires a couple of specialized diagnostic tools that you may not have. Here are some of the easier things to physically check, which can be preventing the proper function of the seats: Mechanical

• Seat track

• Climate controlled seat ducts

Electrical

• Climate controlled seat ducts
• Fuse(s)
• Circuitry
• Driver seat module (DSM)
• Lumbar control switch
• Memory set switch
• Power seat motor
• Seat control switch
• Seat fan motor
• Climate controlled seat module
• Climate controlled seat switch

If your wiring is OK, I would suspect the switch.