Hi Riley:
Nice car, I have the same '93 5.2L V8, according with the Jeep Repair Manual for 1993 at 1998, check this procedure to RESERVOIR REPLACEMENT - REMOVAL
(1) Remove power steering pump. Refer to Pump Replacement in this section.
(2) Clean exterior of pump with solvent.
(3) Clamp the pump body in a soft jaw vice.
(4) Pry up tab and slide the retaining clip off (Fig. 7).
(5) Remove fluid reservoir from pump body. Remove and discard O-ring seal (Fig. 8).
INSTALLATION
(1) Lubricate new O-ring Seal with Mopar Power Steering Fluid or equivalent.
(2) Install O-ring seal in housing.
(3) Install reservoir onto housing.
(4) Slide and tap in reservoir retainer clips until tab locks to housing.
(5) Install power steering pump. Refer to Pump Replacement in this section.
If you need other additional details or some specific section from the Repair Manual, feel free to contact us in the previous links.
Hope this helps; also keep in mind that your feedback is important and I'll appreciate
your time and consideration if you leave some testimonial comment about
this answer.
Thank you for using Fixya, and have a nice day.
1,238 views
Usually answered in minutes!
×