What are some common causes to get trouble code P0351 Primary/Secondary Ignition?

P0351 loss of power ? That's not what this code is about . P0351 - Ignition Coil A Primary/Secondary Circuit ,you have a bad coil and possibly a bad coil driver inside the PCM . Do yourself a favor an take your vehicle to a qualified repair shop !
P0351 - Ignition Coil A Primary/Secondary Circuit Description: See the description for DTC P0350. Possible Causes: See the possible causes for DTC P0350. Diagnostic Aids: See the diagnostic aids for DTC P0350. Application Key On Engine Off Key On Engine Running Continuous Memory Coil-on-plug (COP) ignition testing - GO to Pinpoint Test JF . GO to Pinpoint Test JF . Coil pack ignition testing - GO to Pinpoint Test JE . GO to Pinpoint Test JE .
P0350 - Ignition Coil Primary/Secondary Circuit Description: Each ignition primary circuit is continuously monitored. The test fails when the powertrain control module (PCM) does not receive a valid ignition diagnostic monitor (IDM) pulse signal from the ignition module (integrated in the PCM). Possible Causes:

• Open or short in the ignition START/RUN circuit
• Open coil driver circuit
• Coil driver circuit short to ground
• Damaged coil
• Coil driver circuit short to VPWR

Diagnostic Aids: Use the 12-volt non-powered test lamp to verify START/RUN voltage at the ignition coil harness connector.
Check the coil driver circuit for open, short to VPWR, or short to ground. Application Key On Engine Off Key On Engine Running Continuous Memory All GO to Pinpoint Test JE .

From a reputable repair website:


P0351 - OBD-II Trouble Code

Auto Systems and Repair

Ignition Coil "A" Circuit Primary/Secondary Malfunction Our emissions expert has put together the following information about the P0351 fault code. We have also included diagnostic procedures you can take to your repair shop if the mechanic is having difficulty analyzing the code.
OBD II Fault Code

• OBD II P0351 Ignition Coil "A" Circuit Primary/Secondary Malfunction

What does this mean? The ignition coil or coils are responsible for igniting the air/fuel mixture inside the combustion chambers. Without reliable performance from the ignition coil(s) the vehicle will stumble and misfire.
Code P0351 indicates there's an electrical problem in either the primary ( the computer side ) or the secondary ( the spark plug side ) of the Ignition Coil "A" Circuit.
Symptoms

• Check Engine Light will illuminate
• Engine idles rough
• Engine misfires on acceleration
• In rare cases, the engine may not exhibit noticeable symptoms

Common Problems That Trigger the P0351 Code

• Defective Ignition Coil(s)
• Defective Spark Plug(s)
• Intake Manifold Vacuum leaks
• Carbon buildup in the Throttle Body air passages
• Defective Idle Air Control Valve or Electronic Body

Common Misdiagnosis

• Ignition coil(s) replaced when cause of the malfunction was a vacuum leak
• Spark Plugs replaced when cause of the malfunction was a vacuum leak

P0300 - Random multiple cylinder misfire
P0301 , 302 and 304 - Cyliners 1, 2 and 4 misfire
P0351 - Ignition coil A primary/secondary circuit malfunction
P0354 - Ignition coil D primary/secondary circuit malfunction

Trouble Code: P0300

Multiple Cylinder Misfire Detected
Possible Causes:


Air leak in the intake manifold, or in the EGR or EVAP system Base engine mechanical fault that affects two or more cylinders Erratic or interrupted CKP or CMP Sensor signals Fuel delivery component fault that affects two or more cylinders (i.e., a contaminated, dirty or sticking fuel injector)

Trouble Code: P0302

Cylinder 1-10 Misfire Detected
Possible Causes:


Air leak in the intake manifold, or in the EGR or EVAP system Base engine mechanical fault that affects only one cylinder Fuel delivery component fault that affects only one cylinder (e.g., a dirty fuel injector)

Trouble Code: P0305

Cylinder 1-10 Misfire Detected
Possible Causes:


Air leak in the intake manifold, or in the EGR or EVAP system Base engine mechanical fault that affects only one cylinder Fuel delivery component fault that affects only one cylinder (e.g., a dirty fuel injector)

Trouble Code: P0351

Ignition Coil No. 1, 2 or 3 Primary Circuit
Possible Causes:


ASD relay power circuit to the ignition coil is open Ignition Coil No. 1, 2 or 3 primary "driver" circuit open or grounded Ignition Coil No. 1, 2 or 3 is damaged or it has failed

Trouble Code: P0352

Ignition Coil No. 1-8 Primary Circuit
Possible Causes:


ASD relay power circuit to the ignition coil is open Ignition coil primary "driver" circuit open or grounded

Trouble Code: P0353

Ignition Coil No. 1-8 Primary Circuit
Possible Causes:


ASD relay power circuit to the ignition coil is open Ignition coil primary "driver" circuit open or grounded Ignition coil is damaged or it has failed PCM has failed Ignition coil is damaged or it has failed PCM has failedPCM has failed Ignition system problem (coil or plug) in only one cylinder Ignition system problem (coil or plug) in only one cylinder Ignition system problem (coil or plug) in two or more cylinders Vehicle driven with low fuel pressure or while very low on fuel

yes, the po351 code is Ignition Coil A Primary/Secondary Circuit Malfunction.

Same as Ford Escape.
P0351 - Ignition Coil A - Primary/Secondary Circuit

Cylinder #1, Pin 26 at the PCM, computer.

I would replace the coil on the plug (COP) for that cylinder and see if its' ok. If not, then it is possible that the bad coil took out the driver in the PCM. The test at Pin 26 to see if the light blinks, must be done with the correct tester or it will damage the PCM.

Hope it's the coil.

report results.

4 cylinder or 6 cylinder engine?

P0351 is Ignition Coil A Primary/Secondary Circuit Malfunction.
Possible causes: - Open or short in the ignition coil circuit - Ignition coil circuit shorted to ground - Ignition coil connector - Damaged ignition coil - Damaged PCM or
Possible solution - If damage, repair ignition coil circuit - Replaced ignition coil - Replaced PCM or ECM When is the code detected? The test fails when the Powertrain Control Module (PCM) or Electronic Control Module(ECM) does not receive a valid pulse signal from the ignition coil.
P0351 Description: The ignition signal from the Powertrain Control Module (PCM) or Electronic Control Module(ECM) is sent to and amplified by the power transistor. The power transistor turns ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the proper high voltage in the coil secondary circuit.
Hope this helps :)

P1391 - Not a valid obd code.
B1391 - Oil Level Switch Circuit Failure
C1391 - Not a valid obd code.
U1391 - Not a valid obd code.
Its possible you may have misread this code. If it is B1391 that would be the only code with 1391 for your vehicle.

P0351 - Ignition Coil A Primary / Secondary Circuit Malfunction. The ignition signal from the Powertrain Control Module or Electronic Control Module is sent to and amplified by the power transistor. The power transistor turns ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the proper high voltage in the coil secondary circuit.

Possible Causes:
- Open or short in the ignition coil circuit
- Ignition coil circuit shorted to ground
- Ignition coil connector
- Damaged ignition coil
- Damaged PCM

P0352 - Ignition Coil B Primary / Secondary Circuit Malfunction.
Same repair info as P0351.

P0353 - Ignition Coil C Primary / Secondary Circuit Malfunction.
Same repair info as P0351



Solutions:
- If damage, repair ignition coil circuit
- Replaced ignition coil
- Replaced PCM or ECM

These codes are for a malfunctioning ignition coil/s.
P0351= ignition coil A primary/secondary circuit malfunction.
P0354= ignition coil D primary/secondary circuit malfunction.
visually check the coil packs for burn marks, damage, loose wire connectors, and the wire harness to each of the coils for damage. How long has this been happening? Has any work been done recently? Did the engine compartment recently get wet?