My driver side headlight stopped working, the bright works but not the dim. tried multiple bulbs. drive a 2007 jeep compass limited.

Check the wiring on that light. Also check the bulb with a couple of wires to the battery, or swap the bulb left to right to make sure the new bulb is okay.

Check the ground wires for that bulb circuit. Also the bulb socket for a good connection.

bad connection or bad earth check all connection or bulb

Check the fuse for that side yes you have a fuse for each high and low beams for each side

I am sure that a 12 Volt bulb means it needs 12 Volts. Since you changed the bulb to the other side, why not check the voltage in the working side and see what it reads?

Sometimes the turnstalk can interfere with the lighting. Try pushing the Hazard switch several times and see if the headlights straighten out. I read that too much goes through the turnstalk and that using the Hazards can derail a contact inside the stalk.

If this does not help, you may need a headlight relay in the powerbox. One contact may be dirty or burned down for the wire it feeds. Unless you have a single wire feeding both low beams to the headlights, I would bet the left and right side come out directly through the relay.

my driverside headlight stopped working, the bright will work but not the dim. fuses and power was good, do you think it could be same solution to my prob?

reboot the computer by disconnecting the battery and reconnecting

more likely a fuse problem try to check the fuse boxes inside and on the engine compartment

TEST
remove both bulbs from the lamps but leave them on their wires switch on and see if the bulbs are still different brightness if not they the passenger side lamp housing has damaged mirror is dirty or missalined and needs adjustment. if they are different brightness then this may be a earthing problem.

Try swapping the headlight bulbs or buying a known good bulb and testing that way. Sounds like a shorted bulb filament issue.