Where can i find the idle air control valve on my 1999 Chrysler sebring LXI

Clean the throttle body and check for vacuum leaks.The idle air control may be defective.The IAC may also be fine and shutting off the idle bleed port fully,but other air vacuum leaks may be keeping the idle seed high such as hoses,intake gasket and throttle plate gunk.Use a scan tool to read IAC position.

Chrysler Sebring Questions - Car running very rough ...

www.cargurus.com > Questions > Chrysler > Sebring

CarGurusMar 27, 2011 - It seems after car gets to a certain temperature it runs very rough. ... 2011 at 12:16 PM about the 1998 Chrysler Sebring 2 Dr LXi Coupe ... it.one day it washot out and it was running sluggish with rough idle.and ... I changed the altnator and battery its runs like its brand-new.now ... 2002 Chrysler Sebring LXi.

Chrysler Sebring Questions - Engine Power Loss After Car ...

www.cargurus.com > Questions > Chrysler > Sebring

CarGurusNov 3, 2011 - Engine Power Loss After Car Is Warmed Up - Major loss of power after car has ... When vehicle is cold runs ok, sometimes a little rough but not bad. Full power. Allowed vehicle to run for over 45 minutes last night at idle, died on its own, car sat approximately 20-30 minutes. ... 2002 Chrysler Sebring LX.

* Chrysler Sebring/200 Convertible Club * • View topic - Rough ...

www.sebringclub.net/board/viewtopic.php?p=69097

Dec 29, 2006 - 5 posts - ‎3 authors
However, the vehicle still suffers from rough idle under certain conditions: ... been resolved (I don't think he noticed that it happened only when warm though). .... The test will tell you its general condition without having to dig it out of the fender, ..... Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group rough ...
15 posts
May 24, 2010
Low idle rpm
15 posts
Mar 8, 2007
More results from www.sebringclub.net

They should in the exhaust pipes just before the catalytic converter

check your spark plug wires and coils

clean the throttle body, disconnect the MAF to se if problem goes away. Clean MAF or replace it. Check IAC, idle air control valve, replace if needed. MAF is Mass Air Flow. Use only electronic carb cleaner! Regular carb cleaner will damage MAF.Check throttle linkage for kink or blockage.

Hello degarmo1960,

Below is a wiring diagram showing the idle air control.



I hope this helps.

Regards,

netvan

it's under the TPS Sensor. on the 2.7,

The idle air control, or IAC, valve regulates the amount of air that enters the engine while a vehicle is idling by opening or closing a bypass in the throttle body. Increasing the volume of air...


have a good day !!

Check the fuel filter on car for a restriction. Check the air filter for a restriction(dirty). also check the IAC valve (idle/air/control) located on the side of the throttle body. To check the iac valve, start the engine and disconnect the electrical plug from the iac. Listen for a change in the idle of the engine. then reconnect the plug to the iac valve and turn on the a/c and listen for the engine idle speed to change. If not then replace the iac valve. Hope this will help you.

35,000

ok this sounds easy when you ran the vehicle the computer controled the idiling motor now that you replace the idiling motor the computer hasnt been reset to except the new parameters
once you reset computer this should bring the idle back down to its specified idle
you can also adjust back of gas pedel the idle cable and on the throttle body by the idling screw