1996 Mitsubishi Montero Sport - Page 7 - Answered Questions & Fixed issues
No brsake lights
brake light switch stuck located under dash but usually can be gotten to by looking up under the dash for a switch that will work off of the top of the brake pedal lever.
12/14/2013 7:52:07 AM •
Mitsubishi...
•
Answered
on Dec 14, 2013
•
25 views
My heater and air conditioner shut on and off
The air conditioner is controlled by in cab air temperature so if the air temp is low then the ac compressor clutch will cycle as the thermostat switches it on or off. If you want it to work all the time you may have to run the heat as well so that the thermostat is fooled into thinking that the air temp is hot.. Have the system checked out by an auto electrician
12/6/2013 7:22:17 AM •
Mitsubishi...
•
Answered
on Dec 06, 2013
•
181 views
Green light with 4 wheels on in dashboard
issue with the 4 wheel drive system. contact your mitsubishi dealer and let them diagnose the problem for you. they can pull specific codes out of the PCM that make diagnosing and fixing the problem right the first time more likely.
11/14/2013 5:30:12 AM •
Mitsubishi...
•
Answered
on Nov 14, 2013
•
46 views
I took my 97 Montero sport LS to the shop because
Because a head gasket are not valve seals. What color of smoke is coming out of your tail pipe? if it's burnt oil, have your valve seals replaced. Head gaskets seal the space between block and the cylinder head. I don't know why your head gasket was replaced when a shop told you your valve seals need to be replaced...makes no sense.
10/24/2013 5:29:52 PM •
Mitsubishi...
•
Answered
on Oct 24, 2013
•
232 views
01 montero sport will sometimes not start on cold
How long has it been since these parts been replaced? Could it be the mechanics fault that it is not right again? ALso, I think you are suppose to reset your codes after repairing the error code issue if I'm not mistaken.
10/3/2013 2:54:41 PM •
Mitsubishi...
•
Answered
on Oct 03, 2013
•
212 views
Turn signal switch repair
The steering column wheel has 2 pins pushed into the back side of it and as you turn the steering wheel making a turn, the pins slide over the humps of the blinker signal. As you return the wheel back to center to drive straight, these pins then hit the humps in the turn signal and push the turn signal back to the original position. It sounds like one of these pins fell out or broke off. You need to pull steering wheel and check to see if these pins are still inserted on the back side of the steering wheel.
10/3/2013 2:05:01 PM •
Mitsubishi...
•
Answered
on Oct 03, 2013
•
188 views
Not finding what you are looking for?