20 Most Recent 1993 Chrysler Town & Country - Page 9 Questions & Answers

NO CRANK SIGNAL AT PCM

CHANGE KEY CYLINDER FIRST

GOT A BAD ONE CHANGE AGAIN

CHANGE IT

TUNE UP

WHEN BRAKING WARPED ROTORS ARE FRONT SHIMMY, ON SMOOTH ROAD IN NEUTRAL WHEEL BALANCE, WHEN IN GEAR ACCELERATING FUEL/TUNE UP , SLOWING DOWN TRANSMISSION DECEL DOWNSHIFT. MAKE SURE MUFFLER SYSTEM IS FIRMLY ATTACHED, NOTHING LOOSE AFTER ENGINE IS COOL

WHAT YEAR CAR ? TRANSPONDER NEED COMPUTER, OLD KEY STYLE REPLACE CYLINDER, TRY GRABBING WHEEL AND TURN WHILE TURNING KEY,MIGHT RELEASE LOCK ON CYLINDER

REAR TONE WHEEL HAS SENSOR

ON ENGINE BLOCK

AAUTO ZONE WILL SCAN CAR TELL YOU FOR FREE!!

POWER PACK NEAR BATTERY HAS ALL THE RELAYS, SWITCH OUT A WORKING ONE INTO SIGNAL RELAY AND SEE IF THAT WORKS, IF IT DOES THEN YOU HAVE A BAD RELAY AND REPLACE

Click on the link. Click on wiring diagrams, follow the links, year--make--model, all that good stuff. Every time I post a wiring diagram, it gets deleted. I guess the site is worried about copy-write material, even though it is all over the web. http://bbbind.com/free_tsb.html

on what post your question on youtube but make and model it is there if you post your question right ,good luck

it,s located in the fuse panel refer to your owners manual

Inspect both the front and rear brakes. Including rotors, drums( if equipped in rear), abs sensors and wiring to the sensors, and brake pads/shoes. Also be sure to remove the calipers and look at the brake pads to check for worn out or uneven wear and replace if necessary. Hope this helps

If the engine idle is too fast the choke is not working properly. Notice if the engine is running at a high idle when you put it in neutral after this occurs.

in TOTALLY INTEGRATED POWER MODULE under the hood. should be M10 20 amp.

There is a throttle position sensor. Most likely cause of your problem is a vacuum leak. The coolant temperature sensor signal is used by the computer to meter fuel to the injectors when the coolant sensor goes bad the car will be slow to start the first time and there will be a strong odor of gasoline , turn it off and it starts right up.

run the fault codes. Take it to another shop for a second opinion