20 Most Recent 1993 Chrysler Town & Country - Page 8 Questions & Answers

A Chrysler dealer will be able to get that information for you.

Take an have a factory scan tool hooked up to diagnose what's wrong ! Oxygen Sensor Test fixed rich signal http://www.obd-codes.com/p0172

The oil pressure light came on because the van stalled. When a vehicle stalls it looses all oil pressure triggered the light

Clogged catalytic converters can also throw this code.

In fuse box in engine compartment

Check fuses and relay one fan on means only working in low mode.

check the coolant level while car is running with radiator cap off

Any check engine light or error codes? I would guess it should be saying it is not getting data or "correct" data from the Block temperature sensor that feeds information to the ECU and the plug timer computer. More than likely corroded contacts. I had similar problem with a 20 yr old car. I disconnected the female connector cleaned with electronic contact spray cleaner and used a toothpick to clean the connector. I also cleaned the male spade connector on the temp sensor with the same spray cleaner and scraped the spade with a sharp blade to bright metal. Put back together, cleared the codes and wala, instant start up just like new. There may be other issues like vacuum line leaks that cause the "give it the gas" hesitation. If you need repair manual try this http://www.manualslib.com/

you acces the blower motor thru the glove box by removing it.

All? google your question like this: 2003 chrysler town and country grand caravan: error codes Or maybe a repair manual here: http://www.manualslib.com/

https://www.youtube.com/watch?v=mvfHkKolbO4

The most common causes are a restriction in the filler tube, or a problem with the tank vent.

check the wiring at the top of your tail gate may have a break in it.

You wont find it here

I'm leaning more toward you feul pump and filter my friend, a 2000 town and country? Filter is underneth the drivers side and the pump is in the feul tank

depending on how loud it is. it could b a thrown rod. or a lift.

Chilton or Haynes manual. and its not easy to say the least

EASY ACCESS, REMOVE FRONT BUMPER SKIN FOR BOTTOM 2 BOLTS, AND THERE IS 1 ON TOP ,THAT YOU CAN SEE