20 Most Recent 2006 Mercury Mountaineer - Page 7 Questions & Answers

my 6cd changer will not run..unable to eject cd or load them..sounds like some motor is running and then stops..very upset..live my system need it to work

Take it to Autozone to get scanned. It is on because the computer has found a problem. They will check it for free and they will let you know what is wrong.

I believe what your saying and what they are saying

Your radiator issue was resolved,now move on

Start fresh,check for codes,work them first
No Codes use the scanner to look at data
Will need a wiring diagram

I can't guess at your issues, but I would believe
that NAPA Care Care should be able to diagnose

Just be there,in the service bay,next to your
vehicle, and see the test proceedure and results
first hand,before you authorize you money to change
hands.

it should be on the inside of the frame rail

This is caused by the fact that the air that must be expelled from the tank when you fill it in has no other place to go but thru the nozzle pipe - most likely because the air tube to the carbon cannister is closed by the valve or the cannister itself is clogged. The easiest way to fix that is to just take out the tube to the cannister and leave it in the open - but you will loose some fuel thru evaporation (what the cannister was designed to prevent).

You have to have someone reset it. The dealer or some autoparts stores can as well. Autozone and maybe advanced auto.

The check engine light is blinking because a misfire has been detected by the computer take the car to autozone and have them scan the computer for trouble codes they do it for free this will determine what cylinder is misifiring, after you know the trouble code you can further diagnose what the problem is and fix it...

According to Page 11 of this PDF:

http://www.motorcraftservice.com/pubs/content/~WO6MNT/~MUS~LEN/41/06mntog1e.pdf

What you describe sounds to be "Check the Fuel Cap"

alternator not charging

On the console, where the oil change light is on, scroll through the items until you get to oil life. Once at oil life, hold the reset button and it will say Engine oil new. Press reset again and this should set you oil life back to 100% .

drivers side of vehicle

In the fuel tank, part of fuel pump assembly, fuel tank will have to be remove for service.

The light switch that controls it is defective or there is a short to ground in the circuit.